Can a New Holland square baler tie a bale?
Can a New Holland square baler tie a bale?
New Holland 268 square baler wouldn’t tie a bale. The knotters would get a bunch of twine wrapped up and it would be a mess. It’s an easy fix in this case Loading…
Why are the knotters on my square baler not tying?
Over the years, if you’ve owned a small square baler, chances are you’ve probably had problems with knotters not tying. So here is a general guide to help deal with this unexpected challenge which always seems to happen with a full crop in the field.
Where is the time mark on a New Holland Baler?
It is located on the right side of the bale chamber next to the twine box. Grab hold of this rod down where it connects to the needle yoke and give it a pull towards the rear of the baler. It should come back a little. If you do not do this, it will be out of time. The next step is to check and see if the timing marks line up.
Where is the needle yolk rod on a New Holland Baler?
One other important thing is the needle yolk rod. It is located on the right side of the bale chamber next to the twine box. Grab hold of this rod down where it connects to the needle yoke and give it a pull towards the rear of the baler.
How do I time a New Holland 273 square baler?
Grab hold of this rod down where it connects to the needle yoke and give it a pull towards the rear of the baler. It should come back a little. If you do not do this, it will be out of time. The next step is to check and see if the timing marks line up. If not, then remove the chain
Over the years, if you’ve owned a small square baler, chances are you’ve probably had problems with knotters not tying. So here is a general guide to help deal with this unexpected challenge which always seems to happen with a full crop in the field.
What to do when your baler is out of time?
Adjust the needle yoke rod to prevent it from hitting the bottom of the bale case. Check knotter timing. Make sure the correct shear bolt is used. Needle safety latch may be frozen or the linkage out of adjustment or inoperable. The baler may be out of time. Check plunger needle slots for debris buildup or for something lodged in needle slot. FG
One other important thing is the needle yolk rod. It is located on the right side of the bale chamber next to the twine box. Grab hold of this rod down where it connects to the needle yoke and give it a pull towards the rear of the baler.
