Can a car have no brake warning light?
Can a car have no brake warning light?
If no warning light is on for the regular brake system but you have the ABS light on you will have functioning brakes but no ABS function. You first stated the ABS light on with no codes.
Why does my GM ABS brake still run?
The antilock brake system (ABS) is controlled by its own computer. When it senses a problem, the ABS module on the dashboard will light up. When the problem is fixed, the module will sometimes still stay on, and it will need to be rest.
Is there an ABS light with no codes?
I have a solid abs light when I turn my truck on, but when I plugged in the scanner I got no codes. The 3 fuses are good, replaced them to make sure and still lights on with no codes. I reset the light several times and it would stay off until I got to around 5-10kph and than it would go solid again with no codes.
How can I reset the GM ABS brake module?
Navigate to the “ABS” menu on the computerized scan tool by pushing the down arrow button. Select “Clear all codes.” Power off the computerized scan tool and disconnect it from the DLC connector. Turn on the vehicle and verify that the ABS module is no longer lit. A computerized scan tool can be purchased online, or at any automotive supply store.
The antilock brake system (ABS) is controlled by its own computer. When it senses a problem, the ABS module on the dashboard will light up. When the problem is fixed, the module will sometimes still stay on, and it will need to be rest.
Can you reset the ABS light on a Chevrolet?
Keep in mind that you can’t reset the ABS light on your Chevrolet until you fix the problem that triggered the ABS light. Rember to check the brake fluid level. If the level is below the MIN mark, add ONLY the brake fluid type noted on the brake fluid cap. Typically it will be DOT 4 Brake Fluid but check the cap in your Chevrolet to verify.
Navigate to the “ABS” menu on the computerized scan tool by pushing the down arrow button. Select “Clear all codes.” Power off the computerized scan tool and disconnect it from the DLC connector. Turn on the vehicle and verify that the ABS module is no longer lit. A computerized scan tool can be purchased online, or at any automotive supply store.
Is it possible to have an ABS light but no codes?
Connector is shown in figure 5E1-16 See also “system diagnosis chart B “Anti-Lock” Lamp on and no abs codes present. If I was getting that, I’d try just adding a ground wire right at the EBCM mount but 4.4 ohms should not bother it.
