Are there any problems with the International 4300?

International 4300 owners have reported 11 electrical system related problems since 1996. Table 1 shows the 5 most common electrical system problems. The number one most common problem is related to the vehicle’s electrical system (6 problems).

When did the 2003 International 4300 catch fire?

The company owns a 2003 International 4300. The contact was waiting for a tire mechanic to arrive when he noticed smoke underneath the wheel of the vehicle. The vehicle caught fire on June 10, 2008 in the engine compartment, and was destroyed.

Why is my international dump truck not working?

The contact owns a 2005 International 4300 dump truck. The contact stated the engine would slip into idle mode and when depressing the accelerator pedal, it would not respond. The failure occurred while driving various speeds.

How to reset a / C on International trucks?

You can by pass each of the 2 thermistors with a 1500 ohm 1/2 watt resistor at the harness plug. Without Diamond Logic you can not monitor thermistor temp. so this is the way that you can quickly make sure that your thermistors are working. (after you remove battery cables for 5 minutes to reset) It works!

How to reset ABS light on an international 4300 2001?

Vocational, Technical or Tra… hyd..abs light..my truck pulls to the left when i hit the brakes. Vocational, Technical or Tra… We have a 03 int tow truck 4300 dt466e? , have access to mitchell med duty info. The abs light is on.. is there a way to manually scan the abs … read more I have an international 2007 4300 dt466.

What should the fuel pressure be on an international 4300?

Need 20 psi to start, 65 psi when running. Hold your schrader valve open during crank to make sure there is solid fuel flow there. If you have the test fitting on the fuel filter cap, you can check for pressure there too. Even the hand primer pump should be able to build up to 60 psi and get hard. spsauerland Thanks this.

What kind of engine does a 2005 International 4300 DT 466 have?

Here is a little more info. 2005 international 4300 dt 466 trimmed y 225 hp. Single drive axel, 6 speed manual with air brake and air ride. I know it sounds weird, but have you checked your ride hgt?

How much Freon does an international 4300 hold?

PUT TWO NEW THERMISTERS IN IT,part #3622764c3 and if its a two door cab it should hold 2 lbs of freon and if its a extra cab it should hold 2.25 lbs.hope this helps.

What should the high pressure switch be on an international 4300?

Sounds like the high pressure switch is bad. The high side should go up close to 300psi before it cuts the compressor off. The normal opperating range for the high side is 180-250 and your not getting that.

What’s the normal opperating range for a 4300?

The normal opperating range for the high side is 180-250 and your not getting that. yes the cabin air filter was changed at the same time as the orifice tube and accumulator (about 4k miles ago). would a bad high pressure switch kick it off at a lower psi and be consistent about it?

How do you find the engine code on an IH 4300?

You then count and record the flashes of the Amber engine light. They are 3 digit codes. The code list is in the stickies I believe. A bit of a PItA but it works. To clear codes you hold the buttons, turn key on and pump throttle 3 times.

How do you clear a code on a 4300?

To clear codes you hold the buttons, turn key on and pump throttle 3 times. Well I tried it on the truck im driving. (2002 4300 dt466e) No flashes.

Is there a problem with the 2012 int 4300?

2012 Int 4300 w/ maxforce dt. I have a problem w/ engine perf. 2012 Int 4300 w/ maxforce… 2012 Int 4300 w/ maxforce dt. I have a problem w/ engine perf. no power. Keeps wanting parked regen. Has codes 3719 and 3556 in it.

What’s the ABS light on an international 4300?

2012 INTERNATIONAL 4300 DT466 MAXFORCE… *****************. I HAVE AN ABS LIGHT AND WARNING BEEPER CONSTANT, I HAD A … read more Our 2009 International 4300 MaxForce DT (7.6L) truck is shifting into neutral as we are driving down the highway. We have to pull off and turnoff engine 5 minutes and then restart and drive for anothe … read more

What’s the electric fault on an international 4300?

I have an international 4300 and the electric fault and abs… Vocational, Technical or Tra… I have a 2012 international with datalink issues Data link issues. Looking for help troubleshooting cause

How to reset the HVAC on an international 4300?

Click to expand… The right way is to remove the HVAC Control B+ fuse to accomplish a reset, just as mrdevildog suggests, there is then no risk of damage to the controller or dash panels.