Common questions

Why is my fuel pump not working on my S10?

Why is my fuel pump not working on my S10?

If you are unsure, check out this article on troubleshooting catalytic converters. If you get P0420 or P0430 trouble codes with a scanner, it very well may be the catalytic converter causing these symptoms. One of the best indicators of a clogged fuel pump is going to be that the your S10 is difficult to start.

What are the symptoms of a bad fuel pump?

Without gas your S10 will not run at all. With that in mind, most of the symptoms of a bad fuel pump revolve around the vehicle stalling out or not running at all. In modern fuel injected vehicles, the fuel pump sits right in the fuel tank and “pushes” the gasoline to the fuel rail (s).

When does a 2001 Blazer start to bog down?

I have a 2001 Blazer, last week as I was climbing a hill I attempted to accelerate and heard a “pop” and my engine started to bog down. Over this last week the bogging down has got progressively worse but only happens when you attempt to accelerate.

Why does my Chevy Blazer have no power?

If not that code then your problem is most likely the cheap plastic distributor that GM installed for that year. Take off that expensive cap and see if the shaft jiggles. It is better to remove the distributor to inspect it. AutoZone sells a lifetime warranted Distributor for about $90.

If not that code then your problem is most likely the cheap plastic distributor that GM installed for that year. Take off that expensive cap and see if the shaft jiggles. It is better to remove the distributor to inspect it. AutoZone sells a lifetime warranted Distributor for about $90.

I have a 2001 Blazer, last week as I was climbing a hill I attempted to accelerate and heard a “pop” and my engine started to bog down. Over this last week the bogging down has got progressively worse but only happens when you attempt to accelerate.

Why does my truck not start after a fuel pump replacement?

WELL I COULD HERE IT COME ON BUT NO GAS COMING OUT OF THE FUEL LINE WHERE I DISCONNECTED THE FUEL FILTER LINE TO CHECK IF IT WAS PUMPING GAS TO THE ENGINE AND NO LUCK !!!! SO HERE IS THE DEAL ON THIS PROBLEM WELL TWO OF THE WIRES WERE CROSSED !!!!

Where is the po300 code on a Chevy Blazer?

Or PO300 (Random/Multiple Cylinder Misfire) code. Both of these problems have symptoms you’ve described. The first (Mass Air Flow) is located on the air breather intake (looks like a honey Comb). If not that code then your problem is most likely the cheap plastic distributor that GM installed for that year.

Why does my Chevy S-10 not start up?

Once the truck starts and is running you can remove the jumper to the fuel pump and it will continue to run. The only thing i can think of is that you are not getting the priming signal to the fuel pump, that the ECM if faulty. It turns over fine.

What to do if your fuel pump wont start?

For future reference, I had this same problem when replacing the fuel pump on my 2002 s10 4.3L. Searched forever for an answer. It turns out that in order to remove the bed of the truck, you must disconnect the ground for the fuel pump, which attaches in the rear on the drivers side.

Why is my fuel pump relay not working?

I have replaced the fuel pump relay oil pressure switch and computer. If you’re not getting a signal for fuel, then you either have a faulty crank sensor, or bad ignition module. But the truck runs great until you cut it off. If you poor a little gas in the intake to get it started would that only effect the starting ? Ok.

If you are unsure, check out this article on troubleshooting catalytic converters. If you get P0420 or P0430 trouble codes with a scanner, it very well may be the catalytic converter causing these symptoms. One of the best indicators of a clogged fuel pump is going to be that the your S10 is difficult to start.

Once the truck starts and is running you can remove the jumper to the fuel pump and it will continue to run. The only thing i can think of is that you are not getting the priming signal to the fuel pump, that the ECM if faulty. It turns over fine.

For future reference, I had this same problem when replacing the fuel pump on my 2002 s10 4.3L. Searched forever for an answer. It turns out that in order to remove the bed of the truck, you must disconnect the ground for the fuel pump, which attaches in the rear on the drivers side.

Without gas your S10 will not run at all. With that in mind, most of the symptoms of a bad fuel pump revolve around the vehicle stalling out or not running at all. In modern fuel injected vehicles, the fuel pump sits right in the fuel tank and “pushes” the gasoline to the fuel rail (s).

What happens when a fuel pump goes bad?

The engine turns off if the combustion chamber’s fuel is inadequate or doesn’t have the proper pressure. The part that ensures none of this happens is the fuel pump, and it cannot work perfectly if the fuel pump relay develops any issues. A faulty fuel pump relay can also cause the engine not to start at all and be completely dead.

When is the fuel pump relay turned on?

The fuel pump relay is an important component of the fuel system of your vehicle. The fuel pump relay gives the fuel pump power when it is time to build up fuel pressure in the rail. Whenever you turn on the ignition of your vehicle, the fuel pump relay is turned on. There are different reasons due to which the fuel pump relay fails.

Why does my 1994 Chevy S-10 not start?

1994 Chevrolet S-10 4.3 tbi. I never get the signal to turn on the fuel pump or fire the injectors but if i poor gas in the intake once the truck starts it runs fine. Any ideas ? I have replaced the fuel pump relay oil pressure switch and computer.

How does the fuel pump know when to shut off?

Some vehicles can vary the voltage to the fuel pump to control fuel pressure. In the case of an accident, there are many crash sensors on modern cars that the PCM will monitor. When an accident has been registered, the PCM has the option to cut power to the fuel pump by turning off the fuel pump relay. Was this answer helpful?

Is there no power to the fuel pump?

No power to the fuel pump and the fuel relay is not getti… Q: No power to the fuel pump and the fuel relay is not getting power. My car has 190000 miles.

What are the symptoms of a bad fuel pump relay?

A bad fuel pump relay can cause many different symptoms. Here are the most common ones The fuel pump relay is an important component of the fuel system of your vehicle. The fuel pump relay gives the fuel pump power when it is time to build up fuel pressure in the rail.

What causes a Chevy S10 to not start?

Often it’ll be bad spark plugs, or a bad coil pack. If the fuel pump has completely failed, the engine won’t start at all. At the most basic of levels your Chevy S10 needs three things to start: Air, fuel, and spark . If any of these things aren’t present, the engine won’t turn over at all.

What to do if your Chevy fuel pump fails?

Chevrolet fuel pump failures are a common and growing problem. If you have a fuel pump harness connector that looks like the flat one on the right or the square one at the bottom, then consider replacing it when replacing the pump. More details about this are below, but you might want to download your Chevy manual to help.

What happens when the fuel pump goes out on a Chevy S10?

There are physical signs that you can feel when your S10’s fuel pump is going out. Before taking anything apart, check to see if your engine’s computer has any trouble codes saved in it. The engine may throw a P0087 trouble code. This trouble code detects that the fuel rail/system pressure is too low.

Often it’ll be bad spark plugs, or a bad coil pack. If the fuel pump has completely failed, the engine won’t start at all. At the most basic of levels your Chevy S10 needs three things to start: Air, fuel, and spark . If any of these things aren’t present, the engine won’t turn over at all.

How to check no fuel condition on GM 4.3L?

I’ve also included how to check a no fuel condition with starting fluid (although this is not the most effective way to test the fuel pump). It’s been my experience that misdiagnosing a bad fuel pump is a common occurrence on the 4.3L, 5.0L, 5.7L GM vehicles with the ‘Spider’ fuel injector assembly.

Why does my gas tank keep getting clogged?

Fuel filters typically have a service interval for when they must be changed. If the fuel filter is not changed for a long time, eventually the particles and sediment from the gas tank will build up and clog the filter, restricting fuel flow.

Why is my Chevy S10 not taking off?

When it asks for a lot of fuel, instead of taking off, it stalls out with the demand. This can be caused by the fuel pump or fuel filter. If your Chevy S10’s engine timing is off, it’s going to stall out, misfire, and altogether not run properly. Here are some of the more common causes of an engine timing problem:

1994 Chevrolet S-10 4.3 tbi. I never get the signal to turn on the fuel pump or fire the injectors but if i poor gas in the intake once the truck starts it runs fine. Any ideas ? I have replaced the fuel pump relay oil pressure switch and computer.

Why does my fuel pump not turn on?

Well getting to start by adding fuel to the throttle body is not going to turn on some special switch that will send a signal to the pump and injectors. I’m sure you probably just have a bad fuel pump that doesn’t have enough pressure or volume to start the truck, but at running speed can keep up.

Where is the throttle position sensor on a Chevy S10?

Your Chevy S10 uses a series of complex sensors to report what is going on to the ECU. The ECU then uses this information to adjust the timing, air fuel mixture, and more. When one of them goes wrong, it can lead to stalling for sure. Throttle Position Sensor – The throttle position sensor is typically located on the gas pedal.

Author Image
Ruth Doyle