Why does my GMC Yukon make a grinding noise?

HEY THERE, I TOO HAVE THE SAME PROBLEM WITH MY 2002 DENALI AND TOOK IT INTO THE DEALER ABOUT 4 TIMES AND ALWAYS WAS UNABLE TO GET AN ANSWER. RECENTLY AT THE GMC DEALERSHIP, I WAS TOLD THAT THE NOISE (GRINDING AND POPING) WAS COMING FROM THE STEERING SHAFT.

What kind of truck makes a grinding noise?

Okay, truck an 04, 1500 Z71 ext. cab and has 320k miles. Original front end. Today, almost all the way to work (20 miles) started to get a faint grinding from the front end. When I got to work, looked for obvious stuff stuck to the axle, but nothing. Going home, it was quiet at first, but after 20 miles, same noise.

Why does my P0300 make a squeaking noise?

Apply pressure to the push rod side of rocker, valve side of rocker and listen for the noise to stop. If the noise changes or stops while applying pressure, the cam lobe or lifter roller for that cylinder is the most likely cause of the problem.

Why does my push rod make a squeaking noise?

If the noise goes away, and you’ve confirmed valve spring, push rod and rocker arm are in good condition, then the cause is most likely a worn cam lobe or lifter roller. Measure the cam lobe lift at the push rod side of the rocker arm.

Why does my GM Truck make a popping noise?

X2.. This is a bad CV joint causing your clicking & popping Jordan. Check it & see if it’s dry. You may just need to pump a little grease into the boot & squeeze it into the joint to stop it if it isn’t too far gone. The fact that the noise is worse on a tight turn just solidifies the outer CV joint as being the problem.

Why is my front wheel grinding and popping?

In our 4×4 system, we have a passenger side axle disconnect actuator. This should make that axle the axle with the least resistance, and the driveshift should be connected to this axle. If it is, the driveshaft will not be turned by a turning wheel.

What kind of noise does front suspension make?

Noise in front suspension ( 05′ z71 ) when turning wheel to the left. Major Vibration?!?!

Why does my GM Truck make a grinding noise?

Original front end. Today, almost all the way to work (20 miles) started to get a faint grinding from the front end. When I got to work, looked for obvious stuff stuck to the axle, but nothing. Going home, it was quiet at first, but after 20 miles, same noise. The noise is almost like that of the 4wd being engaged on dry pavement.

Are there any issues with the GMC Yukon XL Denali?

There are also massive forum threads covering the issue with the pickup trucks. Watkins’ 2016 GMC Yukon XL Denali has had the driveshaft balanced and the tires and wheels switched out two different times, and yet the problems persist, especially the buffeting.

Why does my front suspension make a clunking noise?

This condition may be caused by the jounce bumper slamming into the upper spring seat because it is not retained in the correct up position. The jounce bumper loses position due to oil being deposited onto its retention fingers. The oil is from the strut leaking.

Why does traction control come on on my Yukon Denali?

2004 Yukon Denali came home with wife yesterday. Scraping noise from the front drivers side hub. Turns out that the hub nut need to be tightened. Not sure why but ok. The scraping continued to the end of the driveway and has not returned. After taking care of that, the ABS warning light and the Traction Control warning came on at the same time.

Why does my transfer case make a grinding noise?

From buying research to owner support, join 1.5 MILLION GM Truck Enthusiasts every month who use GM-Trucks.com as a daily part of their ownership experience. My transfer case has started making a horrible grinding noise. First I thought it was coming from the driveshaft or the front/rear diff, but wasn’t sure.

Why does my Chevy Tahoe make a humming sound?

Replaced both front hubs, and all has been well since. My ’04 Tahoe makes a humming sound from the front wheel area, but only at low speed excessive turns, like turning sharp out of a parking spot. it is the same sound that happens when the traction control and ABS kickin on ice.

Why does my Yukon Denali make scraping noise?

Thanks everyone. 2004 Yukon Denali came home with wife yesterday. Scraping noise from the front drivers side hub. Turns out that the hub nut need to be tightened. Not sure why but ok. The scraping continued to the end of the driveway and has not returned.

Why does my truck make a grinding noise?

Clancy, tried your suggestion this afternoon and the truck does not buck or shudder, just the normal 4WD feeling when the front is locked with the rear. Stumpuller6.5 Shits gonna get Abrasive…

Why does my abs light come on on my GMC Sierra?

Im having a problem on my 2004 sierra where my abs light comes on when i hit bumps in the road. but then it will go away either on its own or when i turn the truck off and back on. this all started happening after i got my tires aligned. ive already replaced the front two wheel bearings this year as well 293 people found this helpful.

What does the ABS and brake light on mean?

GMC Sierra 1500 Questions – ABS and Brake light on. What does it mean? – CarGurus ABS and Brake light on. What does it mean? My abs light and my brake light is on, I heard this is a pretty common issue with these trucks.

Why does my GMC Yukon have an ABS light?

Your GMC Yukon’s ABS Light comes on when it fails a self diagnostic cycle. When on, it indicates that the Yukon does not have Anti-Lock brakes, and the safety they provide.

What does the brake light on a Yukon mean?

The brake light indicates that there is a problem with the physical braking system and that your Yukon is unsafe to drive. Yes, you can drive your Yukon with the ABS light on.

Why is my abs light not working on my Audi Q7?

The antilock brake system runs through the ABS module. This module physically controls the anti-lock brake system If it becomes damaged, and can no longer control all four brakes, the ABS light will activate. Typically, corrosion is the most common reason why the module fails.

Why does my GMC Yukon make a grinding noise?