Where is the tensioner on an air conditioner belt?

Where is the tensioner on an air conditioner belt?

If you have a difficult time finding the tensioner, consult the belt routing diagram. This can typically be found on a decal placed somewhere in the engine compartment or in the vehicle repair manual. Step 2: Rotate the tensioner. Use a socket or wrench to slide the automatic tensioner away from the belt.

How do you install an air conditioner belt?

Push or pull the tensioner to a position that allows the belt to be installed onto the pulleys. Once the belt is in place, you can release the tensioner and remove your tool. Step 1: Locate and loosen the compressor pivot.

Where is the AC belt located on a car?

Step 1: Locate the AC belt. The AC belt is routed over the AC compressor, which is located at the front of the engine compartment. You may need to raise the vehicle with a jack and support it with jack stands for access. Step 2: Determine which type of belt you have. Determine which type of belt you have.

Which is the correct way to tension a V-belt?

The meter will report the belt tension in units of force. On new installations, hand rotate the system at least one full revolution of the belt in order to seat and normalize the components. When tensioning an array of V-belts, use a single belt toward the center.

Where is the belt on an air conditioner located?

Replacing the belt at the first sign of wear ensures it won’t break, leaving you without AC. Step 1: Locate the AC belt. The AC belt is routed over the AC compressor, which is located at the front of the engine compartment.

Can a bad a / C belt tensioner be replaced?

Both noises point to a bad A/C belt tensioner. With basic tools and little time, you can replace the tensioner in your Silverado quickly in the comfort of your own garage. This article applies to the Chevrolet Silverado GMT800 (1999-2006).

Where do I find the serpentine belt tensioner?

Step 1: Locate the serpentine belt tensioner. If you have a difficult time finding the tensioner, consult the belt routing diagram. This can typically be found on a decal placed somewhere in the engine compartment or in the vehicle repair manual. Step 2: Rotate the tensioner.

How can I tighten my air conditioner belt?

In order to achieve this, you may need to use a pry bar to put tension on the compressor and hold it in place while you tighten down the pivot bolts. Note: If your compressor uses an idler wheel tensioner, tighten the belt until it’s snug using the adjuster, then tighten down the locknut. Step 5: Check the belt tension.