Where is the starter on a 2000 Ford Ranger?
Where is the starter on a 2000 Ford Ranger?
The starter relay location in the 2000 Ford Ranger is on the left inner fender just behind the battery.
How do you check a Ford Ranger starter?
Since the starter system is being checked, make a check on the starter by using a screwdriver and jumping the solenoid between the two 4-gauge terminals. When these terminals are jumped it sends power to the starter and the starter should activate. If it does, a solenoid is all that is needed.
When to replace solenoid on Ford Ranger starter?
Have a helper turn the switch to the start position while the voltage is checked. If there is 12 volts in the first step and there is 12 volts when the key is in the start position, the solenoid or the starter is bad. On a starter with a solenoid attached, the whole starter gets replaced.
What to do if your starter is not working?
The problem is between the ignition switch and the solenoid so everything in between must be checked. If the fuse is good then check the starter relay. Pull the relay out. Using the voltmeter (with the key off) check the terminals for one that has power. Remember this terminal.
What to do if your Ford Ranger has no power?
If no power, the wiring between the relay and the ignition switch is bad. If there is power, have him hold the switch in the start and put the relay in and listen for it to click on. If not, the ground could be bad. Using the ohmmeter (with the key off) test the two terminals that had no power for continuity to ground.
How do you change the starter on a Ford Ranger?
Video tutorial on how to change the starter on a Ford Ranger. With this starter, it was experiencing jamming issues and would not turn over the engine. If you are stuck in a situation, have another person rock the vehicle while hitting the start position on the key, which will help break the starter free so you can turn the engine over.
Why does my 2000 Ford Ranger not start?
2000 Ford Ranger (3.0 l V6) will not start. Turn key over and nothing happens. I have replaced the starter and the ignition switch. Problem is usually intermittent, although it will not start right now. The starter will crank if I jump the start signal from the battery to the starter, but the truck will not start.
Why is the solenoid on my Ford Ranger not working?
If it does not start, both the solenoid and starter are bad. If there is no voltage at the small terminal on the solenoid, test the solenoid by jumping the small terminal and the battery-side 4-guage terminal and this will activate the solenoid if it is good and operate the starter. If it does not work, then the solenoid is bad.
How big is the starter nut on a Ford Ranger?
The 13-millimeter bolt at the top of the starter here, as well as under this red cap, which we’ll have to pop off. There is a 13-millimeter for the main power supply to the starter solenoid, and a 10-millimeter nut securing the signal wire onto the solenoid as well.
