Where is the seat belt part number?
Where is the seat belt part number?
The part number is usually found on a label near the tongue of the seat belt which makes it easy for a customer to match up the part number from their existing part.
Can you put a new seatbelt in a car?
Replacing the entire seat belt assembly on your vehicle is easier then replacing a single part. When you opt to replace the entire seat belt, you do not need to take apart the old pieces to insert a new belt or to fix a broken retractor. Replacing a seat belt can be accomplished in a short amount of time.
Is it OK to use LATCH and seat belt?
Why Using the LATCH System and a Seat belt Can Be Unsafe By using both the Lower Anchors and the seat belt system when you shouldn’t, the force of the crash will place stress on the wrong areas of the car seat, which can cause the car seat not to function properly.
How long does it take to get a seat belt repaired?
Mail in your seat belt (s) to us for repair. Be sure to include your receipt and mail them to: Done! Your seat belts will be repaired within 24 hours of receiving and shipped right back to you. What exactly do you repair? The seat belt webbing replacement is indeed a repair service that comes with more than you think!
Where can I get a replacement seat belt?
At SeatBeltsPlus.com, we offer aftermarket, replacement seat belts in a variety styles and colors. We offer direct fit, vehicle specific seat belts, as well as universal seat belts. Our direct fit belts are made to factory specifications to bolt directly into your vehicle, just like the original seat belts.
Do you need to remove a seat belt retractor?
If you need to remove your seat belt retractor or pre-tensioner out of your vehicle, this video will show you how to do that step by step. If your car has been in an accident or a crash, we can repair your seat belts!
What can safety restore do for your seat belt?
Here at Safety Restore we specialize in post-accident restorations, repairing locked & blown seat belt retractors, tensioners and buckles. Safety Restore is the leader in post-accident restoration, specializing in resetting SRS airbag modules with crash data and had codes as well as repairing locked & blown seat belt and buckle pre-tensioners.
How to install a 3 point seat belt?
Replacement Seat Belt 3 point formerly, #welr, FMVSS Federal Safety Approved Retractable Belt: CAUTION: Read these seatbelt instructions for 3 point retractable replacement seat belts thoroughly before installing this replacement safety harness.
Where is the best place to replace a seat belt?
When installing your replacement seat belt it is always best to reuse the original factory mounting locations. These locations were engineered by the vehicle’s manufacturer to withstand crash forces.
Where is the anchor point on a seat belt?
When the existing anchor point is located in the side of the drive shaft tunnel: Using the 7/16″ fine thread hex bolt (Grade 5 or better) from the restraint that you’re replacing or a new hex bolt from Wesco, simply insert the hex bolt through the hole in the (D) End of the bucket seatbelt end as shown in Fig. 4 .
How do you replace a WESCO seat belt?
Step # 2: Replacement: Insert the hex bolt through the (A) Retractor End of your new Wesco replacement seat belt and then screw the hex bolt into the existing anchor point (threaded hole) located on the outboard side of the vehicle near the floor as shown in Fig. 1 and tighten.
