Where is the pump on a Dodge Dakota?
Where is the pump on a Dodge Dakota?
The “pump” is called the HCU (hydraulic control unit) and looks little more than a brake line junction box. It will have TWO solenoid looking thingies on the top and has a white,blue,black and one other color wire running to 4 pin connector directly to the Kelsey Hayes little black abs “computer” it’s on the driver side.
How to change the ABS module on a Dodge Dakota?
NOTE: If the CAB is being replaced with a new CAB is must be reprogrammed with the use of a DRB III. (1) Install CAB to the HCU. (2) Install the pump connector to the CAB. (3) Install mounting bolts. Tighten to 2 N·m (16 in. lbs.). (4) Install the wiring harness connector to the CAB and push down on the release to secure the connector.
Can a Dakota have both brake and ABS lights on?
I also recently troubleshooted a 1999 dakota (magnum V6) that had both the brake and abs light on steady, but the brakes were still operating normally (without the abs function of course, which is disabled when the ABS light comes on) and the owner couldn’t clear both ABS/Brake lights either.
Why is my Dodge Dakota idling and dying?
My dakota will start then idle down and die. I can pump the gas and it will stay running but if i hold the peddle down or let off it will die. I have replaced the fuel pump, fuel filter, and the idle air control valve. could it be the map sensor or o2 that is causing this please help. I have had the same problem, and this corrected it.
The “pump” is called the HCU (hydraulic control unit) and looks little more than a brake line junction box. It will have TWO solenoid looking thingies on the top and has a white,blue,black and one other color wire running to 4 pin connector directly to the Kelsey Hayes little black abs “computer” it’s on the driver side.
NOTE: If the CAB is being replaced with a new CAB is must be reprogrammed with the use of a DRB III. (1) Install CAB to the HCU. (2) Install the pump connector to the CAB. (3) Install mounting bolts. Tighten to 2 N·m (16 in. lbs.). (4) Install the wiring harness connector to the CAB and push down on the release to secure the connector.
Where is the antilock brake located on a Dodge Dakota?
The Controller Antilock Brake (CAB) is mounted to the Hydraulic Control Unit (HCU) and operates the ABS system. The CAB voltage source is through the ignition switch in the RUN position.
How to change the battery in a Dodge Dakota?
Stored faults are not erased if the battery is disconnected. NOTE: If the CAB is being replaced with a new CAB is must be reprogrammed with the use of a DRB III. (1) Remove the negative battery cable from the battery. (2) Pull up on the CAB harness connector release and remove connector.
