Where is the fuel pump on a Chevy Aveo?
Where is the fuel pump on a Chevy Aveo?
Lift the floor panel below the bottom of the rear seat, and you will see the fuel tank. Pull apart the electrical connector joining the fuel pump to the car’s electrical system. Remove the four bolts holding the fuel pump in place on the tank.
Why does my fuel pump not start when I change it?
You always want to replace the fuel filter when replacing the fuel pump. This could cause the concern you are having. It may seem as you are getting enough fuel from the pressure regulator but if the pressure from the fuel tank is not correct, it will still not start. Another problem you could be having is spark.
Where does the gas go after a fuel pump replacement?
IT SAID GRAY FROM MY OLD HARNESS GOES TO THE SMALL BLACK WIRE TO NEW HARNESS WHICH WAS WRONG !! SO WHEN I REWIRED IT GRAY TO GRAY ! IT PUMPED GAS RIGHT THRU THE FUEL LINE GOING TO THE FUEL FILTER LINE RIGHT AWAY !!
How do you take a fuel pump out of a car?
Grab the top of the pump, and twist it counterclockwise until the lock tabs in the top line up with the slots in the tank, and you can pull the fuel pump out.
Where is the fuel pump on a 2005 Chevy Silverado?
This video outlines replacement of the fuel pump module on a 2005 Chevy Silverado Pickup in under 1 hours time. The fuel pump module is located in the fuel tank and this process involves lowering the fuel tank and replacing the pump assembly.
What should I do if my fuel pump does not work?
After mechanic replaced… After mechanic replaced fuel pump gas gauge does not work. Took my truck to mechanic for routine maintenance and he replaced the fuel pump. After I got the truck back and filled the gas tank I noticed the fuel gauge wasn’t reading correctly.
Lift the floor panel below the bottom of the rear seat, and you will see the fuel tank. Pull apart the electrical connector joining the fuel pump to the car’s electrical system. Remove the four bolts holding the fuel pump in place on the tank.
Where does the fuel pump go in a truck?
Searched forever for an answer. It turns out that in order to remove the bed of the truck, you must disconnect the ground for the fuel pump, which attaches in the rear on the drivers side. IIRC it ran either in or alongside the harness for the tail light wiring. Once I hooked that back up, my truck started right up.
