Where is the fluid filler plug on a Ford Ranger?
Where is the fluid filler plug on a Ford Ranger?
Like the manual transmission which is available, the rear axle does not have a dipstick to check fluid level. Instead, a filler plug is located in the side of the housing (or in the side of the cover), at a level just barely above the level to which fluid should fill the housing. To Check The Fluid Level:
What kind of lubricant do you use on a 1998 Ford Ranger?
Refill the drive axle housing using the proper grade and quantity of lubricant. Install the filler plug, operate the vehicle and check for any leaks. The 1998 and newer Ford Ranger uses a different style front axle assembly than the 1983-1997 models.
How do you change a front axle in a Ford Ranger?
3) Use a wire brush to clean the area around the differential. This will help prevent dirt from contaminating the differential housing while the cover is removed. 4) Position a drain pan under the drive axle. Loosen and remove all but two of the cover retaining bolts.
How do you drain fluid from a Ford Ranger?
*lf a suction gun is used to drain the fluid, remove the fill plug and insert the suction tube into the fill hole until it rests at the lowest most point inside the housing. Operate the suction gun as per the manufacturers directions. When the fluid is completely removed, skip to the differential filling procedure.
Like the manual transmission which is available, the rear axle does not have a dipstick to check fluid level. Instead, a filler plug is located in the side of the housing (or in the side of the cover), at a level just barely above the level to which fluid should fill the housing. To Check The Fluid Level:
Refill the drive axle housing using the proper grade and quantity of lubricant. Install the filler plug, operate the vehicle and check for any leaks. The 1998 and newer Ford Ranger uses a different style front axle assembly than the 1983-1997 models.
3) Use a wire brush to clean the area around the differential. This will help prevent dirt from contaminating the differential housing while the cover is removed. 4) Position a drain pan under the drive axle. Loosen and remove all but two of the cover retaining bolts.
*lf a suction gun is used to drain the fluid, remove the fill plug and insert the suction tube into the fill hole until it rests at the lowest most point inside the housing. Operate the suction gun as per the manufacturers directions. When the fluid is completely removed, skip to the differential filling procedure.
