Common questions

Where is the blend door actuator on my heater?

Where is the blend door actuator on my heater?

Located left hand side of heater box here is a guide to help you see what you are in for when doing the job with the location of the blend door actuators below. Check out the diagrams (Below). Please let us know if you need anything else to get the problem fixed. helpful? Hello, thank you for the information.

How long does it take to replace blend air door actuator?

Calibration of the actuators will take approximately 30 seconds. Reinstall SJB fuse 15. Turn the ignition switch to the ON position and wait 30 seconds before verifying correct DEFROST/PANEL/FLOOR operation. As far as no heat from the left side, that is a blend air door actuator. Here are the directions for the left side actuator replacement.

Can a heater be removed from a blend door?

If the door is stuck the heater plenum with need to be removed and the problem resolved before installing the new unit. To test the blend door operation and too double check that you are changing the correct actuator motor turn the blower motor on and work the door in each way. You will be able to feel the air change temperature or vent level.

Where is the mode door actuator on a Dodge Ram?

The single mode door actuator is located on the driver side end of the heater-A/C housing unit, close to the top of the distribution housing. The mode door actuator is mechanically connected to the mode door. The mode door actuator is interchangeable with the actuators for the blend air door (s) and the recirculation air door.

Where do I find the actuator blend door?

A blend door actuator is linked to an air control door pivot found on the last drive of the unit; a plastic gear set is frequently rotated from one side to another by the electric motor. An actuator can become faulty if the plastic gear set turns out to be fragile and it breaks.

Where is the heater blend door located?

The Mode door is located on the left side of the heater core box, which is located under the center of the dashboard. The Blend Door and the Mode Door actuator are identical parts. I also believe that the Resirc Door actuator is similar, if not the same.

Where is the blend door and actuator located?

The blend door actuator is typically located closer to the heater core and evaporator than the mode door . The mode door actuator controls which vent (s) air blows through.

How much does it cost to replace a blend door actuator?

The blend door actuator is responsible for controlling the movement of the vents and the direction of the air, so once it’s damaged or broken, you may not have much temperature control in your car. If you need to have this car part replaced, you can expect to pay between $200 and $300 for parts and labor.

Author Image
Ruth Doyle