Where are the low beam and high beam relays?
Where are the low beam and high beam relays?
There is however also a single lowbeam relay, which gets its signal from the body control module. So have a look at this relay first. You could swap the low beam and high beam relay to be sure that the problem is the relay. Both relays are on the junction block, above the fuse box.
Why are my headlights not working in high beam?
If just one bulb fails to work in either high beam mode or low beam mode, it may be the bulb. Most headlight failures that are limited to just high or low beams are related to a relay or the high beam control switch.
How many fuses are in front low beam light?
There are 2 10 Amp fuses, one for each front low beam light (#14 and 15 in the fuse box), so won´t expect for both to blow at the same time. There is however also a single lowbeam relay, which gets its signal from the body control module.
What to do if your headlight fuse is not working?
First, locate the headlight fuse and make sure it is intact. If it is, use a voltmeter to see how much power, if any, is reaching the headlights. If there is no power reaching them, there is a break in the wiring somewhere between the fuse panel and the headlights themselves. Thanks!
If just one bulb fails to work in either high beam mode or low beam mode, it may be the bulb. Most headlight failures that are limited to just high or low beams are related to a relay or the high beam control switch.
What is the fuse for a low beam light?
The number seventeen fuse has has power to both sides of the fuse with the low beams on. The black ground wire for the lamp has 0.1 ohms. With the low beams on and the light bulb out of the connector, the yellow wire reads 11.8.
Is there a problem with the headlight relay?
If that works then your problem is on the control side of the relay. if jumping the relay doesn’t make the lights come on then you have a wire problem between the relay and the headlight. I would bet on it being in the HI / low switch in stearing colum. I found my problem today.
Is there a problem with my low beams?
I have a Gen 4. I have checked all of my fuses just to make sure they were all good. My low beams do not work at all. However, my high beams work fine. If i have the low beams turned on, there is nothing. When i turn on the high beams, they work fine. Heres the wierd part though.
