When to use fault code p0869 in OBD II?
When to use fault code p0869 in OBD II?
OBD II fault code P0869 is a generic code that is defined as “Transmission fluid pressure (TFP) sensor –high”, and is set when the PCM (Powertrain Control Module) detects a significant difference between the actual transmission line pressure, and the desired transmission line pressure. In the context of code P0869,…
What’s the po868 code on a Dodge Ram?
When in drive, it shows 4th gear on the display. After a few minutes the engine light came on and my code reader says it’s PO868. I checked my fluid level and it was normal (cold). I changed out the oil pressure sensor and it briefly went into reverse, but quickly went back to not shifting at all.
What does p0868 mean on a Cummins pump?
And remind them to READ THE INSTRUCTION SHEET that comes with the new pump assy! P0868 is Line Pressure Low, and it means (typically) that your line pressure was 15 psi (or more) below the Desired Line Pressure value, for some short period of time (maybe 1 second or longer).
When does DTC p0933 set on Dodge Ram?
Set Condition: The Powertrain Control Module (PCM) continuously monitors Actual Line Pressure and compares this to Desired Line Pressure. If the Actual Line Pressure is more than 15 psi below Desired Line Pressure for 3.5 seconds continuously, this DTC will set. 1. CHECK FOR RELATED DTCS With the scan tool, read DTCs. Is DTC P0933 present?
OBD II fault code P0869 is a generic code that is defined as “Transmission fluid pressure (TFP) sensor –high”, and is set when the PCM (Powertrain Control Module) detects a significant difference between the actual transmission line pressure, and the desired transmission line pressure. In the context of code P0869,…
And remind them to READ THE INSTRUCTION SHEET that comes with the new pump assy! P0868 is Line Pressure Low, and it means (typically) that your line pressure was 15 psi (or more) below the Desired Line Pressure value, for some short period of time (maybe 1 second or longer).
Set Condition: The Powertrain Control Module (PCM) continuously monitors Actual Line Pressure and compares this to Desired Line Pressure. If the Actual Line Pressure is more than 15 psi below Desired Line Pressure for 3.5 seconds continuously, this DTC will set. 1. CHECK FOR RELATED DTCS With the scan tool, read DTCs. Is DTC P0933 present?
When in drive, it shows 4th gear on the display. After a few minutes the engine light came on and my code reader says it’s PO868. I checked my fluid level and it was normal (cold). I changed out the oil pressure sensor and it briefly went into reverse, but quickly went back to not shifting at all.
