When does the torque converter clutch turn off?
When does the torque converter clutch turn off?
The torque converter clutch is supposed disengage when you step on the brake pedal. It’s also supposed to turn off when the transmission begins to downshift or when the vehicle is moving below 25 mph. When people would complain about torque converter clutch problems and the 125C was installed we ran a quick test.
Where is the torque converter on a car?
The torque converter, in layman terms, is designed to transfer the power from the engine to the transmission. Installed and mounted on what’s known as a flex plate, which is located in between the engine and transmission, the crankshaft will spin this plate, creating the conversion effect.
What are the symptoms of a torque converter problem?
Car symptoms like bucking and stalling can indicate a torque converter clutch problem. However, these two conditions can exist from other root causes. This is why I wanted to discuss it a little further.
How is a torque converter identification catalog organized?
The Catalogue is organized in the following sequence; Manufacturer e.g. Chrysler, Ford, General Motors etc (alphabetically), then by Transmission Type (again alphabetically) and finally by Converter Code (TCS Code).
Why is my torque converter not working on my Chrysler Town and Country?
It means that the Town and Country ‘s computer has detected that there is an issue with the torque converter clutch (TCC) solenoid circuit. The TCC “locks” the drivetrain, which allows for a true mechanical connection between the transmission and the engine.
How does the torque converter lock up on a 700R4?
Torque converter lockup on the 700R4 transmission is controlled by the TCC solenoid. When the solenoid is engaged, fluid is applied to the torque converter clutch, creating lockup and a direct link between the engine and transmission.
Where is the torque converter toggle switch located?
Run the ground wire through the transmission wiring grommet, and attach it to the negative side of the TCC solenoid. Decide where the toggle switch will be located within the vehicle, and install it.
How do you Torque a torque converter on a car?
Place the new transmission pan gasket over the transmission pan, aligning all holes. Press the transmission pan back onto the transmission and hand-tighten the bolts that secure the pan to the transmission. Torque the transmission bolts to the manufacturer’s recommended torque with a small torque wrench.
