When did the John Deere 1020 tractor come out?
When did the John Deere 1020 tractor come out?
The first John Deere 1020 Tractors went out of the factory gates in 1965 and they kept building them until 1973. The John Deere 1020 Tractor first came out at a price of $4,500, but you might be one of the lucky ones who found a good deal lower than that.
When to replace a John Deere load control shaft?
The bushings that sixbales mentioned are item # 16 and should be replaced if you’re replacing the load control shaft seals. The bushings wear and don’t provide enough surface area for the O’ring and back-up ring to seal.
What to do if John Deere shaft leaks?
“I usually change out the shaft, bushings and seals all at once to cover all bases. The seals are tough but can be pulled out with an O ring pick or cotter pin puller.
What is the repair manual for a John Deere lawn tractor?
John Deere Front Wheel Drive Axles 730 , 733 , 740 , 745 , 750 Component Technical Manual (CTM4820) John Deere 110 and 112 LAWN GARDEN TRACTOR Service Repair Manual (Serial No. early to 100,000) John Deere 110 and 112 LAWN GARDEN TRACTOR Service Repair Manual (S/N: 100001 to 250000)
How do you clean a John Deere load control shaft?
The seals are tough but can be pulled out with an O ring pick or cotter pin puller. The fastest and easiest way I have found to remove the bushings is to clean the bush and shaft of any oil, install the shaft as it would normally sit then weld the bush to the shaft ON ONE END then drive shaft and bush fom the diff housing.
Why is my John Deere load control shaft not turning?
The shaft may not turn in the bushings, but there is a constant pull against the shaft any time you have a plow in the ground. The harder the ground, the more the pull against the shaft and bushing. There is also pressure against the other side of the bushing when you have the implement raised.
The first John Deere 1020 Tractors went out of the factory gates in 1965 and they kept building them until 1973. The John Deere 1020 Tractor first came out at a price of $4,500, but you might be one of the lucky ones who found a good deal lower than that.
What to do if your load control shaft leaks?
The bushings wear and don’t provide enough surface area for the O’ring and back-up ring to seal. Also, do a Google search for “load control shaft seals” There are several companies that claim to make replacement parts for load control shaft seals that eliminate the seal some how.
