Common questions

What was the mileage on a 2006 Chevy Colorado?

What was the mileage on a 2006 Chevy Colorado?

The failure and the current mileages were 60,000. The contact owns a 2006 Chevrolet Colorado. While driving approximately 40 mph, the check engine warning light illuminated and the vehicle began to decelerate. The vehicle was taken to an independent mechanic where the mechanic advised that the engine would have to be replaced.

What are the problems with the Chevrolet Colorado?

See all problems of the 2018 Chevrolet Colorado . The check engine light came on it popped up engine power reduced wouldn’t go over 35 miles and hr on the interstate is not a good thing. I pulled over turned car off. Turned key back on started it was fine. A couple weeks later pulling out in traffic check engine. Light.

What does the Check Engine light mean on a 2005 Chevy Colorado?

At the 100,000 mile mark the check engine light comes one indicating the #2 coil is bad. This doesn’t seem to be the problem nor is it in the injectors. It seems with the online forums that are out there indicates there was a problem with the head on the 2005 Colorado but Chevrolet or gm is not investigating or talking about it.

How long has my Chevy Colorado been in service?

The service manager reported this has been a problem with this particular engine and my online research revealed that Chevrolet recognized this problem and extended the warranty coverage to 7 years and 100,000 miles. My vehicle only had 87335 miles, but had been in service for 9 years, 7 months.

How many miles does a Chevy Colorado have?

I meant Colorado. My 2004 5 cylinder Colorado has 75,000 miles on it. About two months ago when I was filling it with gas, the gas didn,t shut off and it overflowed. I’ve caught it doing this a couple of times since.

Why does my Chevy Colorado start so hard?

It does start but takes a long time compared to other starts. The service engine soon light is on and my mechanic says it’s because the new fuel cap doesn’t seal properly because the gas tube is bent due to the gas pump nozzles resting on it. This I understand but don’t understand why it overflows and starts so hard.

Author Image
Ruth Doyle