What size bearing is a L44649?
What size bearing is a L44649?
1.063 inches
The inner diameter of bearing # L44649 is 1.063 inches. The inner diameter of bearing # L68149 is 1.378 inches. Both fit on a #84 spindle. The matching race for bearing L44649 is # L44610.
How to adjust a wheel bearing on a front non drive axle?
To adjust the wheel barring on a front non-driving axle begin by torquing the inner adjusting nut to to 200 ft. lbs. To seat the bearing rollers and the wheel seal, always rotate the hub while torquing the nut. Torque the adjusting nut to 200 ft. lbs. while rotating the hub.
How to replace a wheel bearing on a Ford?
1 If the wheel hub is very worn, the hub may fall off into your hands after you start wiggling it. 2 Attach the hub puller tool to the wheel hub using the wheel lugs. Secure the hub puller tool with the lug nuts. 3 Apply fast, hard tugs with the slide hammer to pull the wheel hub away from the wheel bearing’s center race. …
How to loosen the axle shaft nut on a Toyota?
1. Loosen the Axle Shaft Nut With the car in park and the parking brake on, remove the wheel cover to expose the axle shaft nut. If an impact driver is not available, straighten and remove the cotter pin and remove the axle shaft nut cover (see E, F, G below).
How to replace AWD front hub bearing assembly?
Prop open the wheel center cap and start spraying the PB Blaster right away. The more time it has to soak in the better. Straighten and remove the locking pin with a plier. At this point do not jack up the truck yet. You gonna need the friction on the tire to loosen the hub nut. Find yourself a nice breaker bar.
What do you need to replace front axle bearing?
You will need the proper size socket to remove the axle nut and a torque wrench of proper capacity to tighten it. What were the symptoms that made you think the bearing was bad?
Prop open the wheel center cap and start spraying the PB Blaster right away. The more time it has to soak in the better. Straighten and remove the locking pin with a plier. At this point do not jack up the truck yet. You gonna need the friction on the tire to loosen the hub nut. Find yourself a nice breaker bar.
What should I use to remove axle nut?
Wasn’t a problem getting the axle nut off with a 18″ breaker bar, but the bearing had practically welded itself on there.
How much torque should I put on my front bearing?
Don’t torque them yet. Be sure that the axle is straight and there is no binding, then start torqueing the bolts in steps up to 85 ft/pounds, to prevent binding. I went from 25, 50 and final torque in a criss cross pattern.
