What should I do during a drive cycle?
What should I do during a drive cycle?
When executing the procedure for this monitor, stay in part throttle mode and drive in a smooth fashion to minimize “fuel slosh”. STRICT OBSERVANCE OF POSTED SPEED LIMITS AND ATTENTION TO DRIVING CONDITIONS ARE MANDATORY WHEN PROCEEDING THROUGH THE FOLLOWING DRIVE CYCLES.
How to pass inspection and complete a drive cycle?
If you have a Code Scout 700 http://amzn.to/Nnwvot you can get a reading that tells you how many monitors are ready and how many are incomplete. All 8 monitors need to be in a “ready” status before you can pass inspection.
Where can I find the OBDII drive cycle?
The OBDII Drive Cycle will be performed using a scan tool. Consult the instruction manual for each described function. NOTE: A detailed description of a Powertrain Control Module (PCM) Reset is found in this section, refer to the table of contents.
How to perform a basic drive cycle-repairpal?
The Drive Cycle and Emissions Readiness Monitors have, for the most part, stopped this unethical tactic. Here are step-by-step instructions on how to perform a basic, yet very effective, drive cycle that will complete the readiness monitors for your vehicle’s emissions control system.
What do you need to know about a drive cycle?
Let the vehicle sit for more than 8 hours. The first step of the drive cycle is a cold start. In order for the test to begin, the engine temperature needs to match the outside ambient temperature. It’s also important to keep the vehicle in a temperature-controlled area. Double check the keys and doors.
If you have a Code Scout 700 http://amzn.to/Nnwvot you can get a reading that tells you how many monitors are ready and how many are incomplete. All 8 monitors need to be in a “ready” status before you can pass inspection.
What should fuel level be for drive cycle?
There are a few general items that need to be completed in order for the drive cycle test to be effective: Make sure the fuel level is between 30 and 70 percent.
