What kind of oil does a 96 Jeep Grand Cherokee take?
What kind of oil does a 96 Jeep Grand Cherokee take?
Engine Oil
| Viscosity: | 10W-30 (Above -18) 5W-30 (Below 16) |
|---|---|
| Capacity: | 6 quarts (with filter)After refill check oil level. |
| Torque: | 30 ft/lbs (Oil Drain Plug) |
What kind of transmission fluid do I need for a 2001 Jeep Grand Cherokee?
The 2001 Jeep Cherokee has a transmission fluid capacity of up to 10 quarts. This vehicle uses ATF 4 automatic transmission fluid in its reservoir.
What kind of crank is in a 1996 GM Quad 4 engine?
1996 VIN T – The crank for the 2.4L engine has a longer stroke, narrower rod journals, a smaller, but wider reluctor wheel that has all the notches in different locations, and a chain sprocket for the balancer. It’s a 4620 casting.
What kind of oil pump does a GM Quad 4 use?
We have seen them with A76 and B77 cast on the beam. There have been three oil pumps used on the 2.3L Quad 4. The oil pump was bolted to the block and driven by a helical gear on the crank until ’95 when it became part of the balancer assembly and was driven by the secondary balance shaft.
When did GM stop making Quad 4 engines?
1990-’95 ALL – There were two more rods used in the Quad 4 engines during these years. Both have been superseded to one part number according to the microfiche. The second version of the rod looked just like the first one, but the pin was floated in the pin bore without a bushing.
How many valves does a GM Quad 4 have?
The Quad 4 had four valves per cylinder, tuned intake and exhaust manifolds, no distributor, no plug wires, lightweight rods and pistons to reduce shaking forces, and a crank with eight counterweights that was designed to reduce noise, vibration and harshness (NVH) and bearing wear.
1996 VIN T – The crank for the 2.4L engine has a longer stroke, narrower rod journals, a smaller, but wider reluctor wheel that has all the notches in different locations, and a chain sprocket for the balancer. It’s a 4620 casting.
We have seen them with A76 and B77 cast on the beam. There have been three oil pumps used on the 2.3L Quad 4. The oil pump was bolted to the block and driven by a helical gear on the crank until ’95 when it became part of the balancer assembly and was driven by the secondary balance shaft.
Where was the Oldsmobile Quad 4 engine made?
Quad 4 engine. All engines in the Quad 4 family were produced at the Lansing Engine Plant (plant five) in Delta Township near Lansing, Michigan. The Twin Cam was the last engine that was engineered and produced solely by Oldsmobile; the Aurora V8 and Intrigue V6 shared architecture with the Cadillac Northstar .
1990-’95 ALL – There were two more rods used in the Quad 4 engines during these years. Both have been superseded to one part number according to the microfiche. The second version of the rod looked just like the first one, but the pin was floated in the pin bore without a bushing.
