What kind of engine does a 1971 Corvette have?

+90 lb. (With Standard Engine, Manual Transmission) +100 lb. (With Standard Engine & Automatic Transmission) +94 lb. (With 454 Cubic Inch Engines & Four Speed Transmission) Notes: Base Corvette Coupe with 350 cu. in. 300 hp engine and wide ratio four speed manual transmission: $5,496.00.

Where is the transmission number on a 1971 Corvette?

1971 Corvette Transmission Identification & Transmission Number Location: 3 & 4-Speed Manual (Saginaw) – Stamped on right-hand side of case in the upper forward corner. 4-Speed (Muncie) – Stamped on the top right-hand side of the case. Turbo Hydra-Matic Automatic – Name plate tag on right-hand side of case.

When did they stop making the 1970 Corvette?

The United Auto Workers (UAW) labor dispute that occurred in May, 1969, which had caused the 1969 model year to run over by two months, had also shorted production of the 1970 Corvette by over four months.

What was the curb weight of a 1971 Corvette?

To learn more about the 1971 Corvette, click here . Shipping Weight: Weight of basic vehicle with regular equipment, including grease, oil, engine coolant to capacity and (3) gallons of gasoline. Curb Weight: Shipping weight plus gasoline to capacity. +90 lb.

Where is the transmission on a 1973 Corvette?

The Muncie M20 wide-ratio 4-speed has been installed behind a 190-hp, 350-ci engine in this 1973 Corvette. (Note the shifter, shifting levers, and the reverse lockout cable.) The transmission is attached to the frame with two bolts on a bracket that bolts to the frame and to the transmission extension. The exhaust is also mounted onto this bracket.

Are there any 1971 Corvette Stingrays for sale?

1971 Chevrolet Corvette Stingray Convertible One of one, numbers matching, unrestored survivor Never been apart except to replace clutch/flywheel/throwout bearing/pilot bearing Milla Miglia red lac… More Info › 1971 Corvette for sale. A great Vette.

Also available, a close-ratio version with a 2.20:1 low (close ratio not available with 270-hp engine, wide range not available with 425-hp engine). A Special 4-Speed close ratio box is available with the 425-hp V8. With the 270-, 365-, and 425-hp engines, you can order Turbo Hydra-matic.

Where is the distributor on a Chevy LT1?

One of the other major changes was the distributor. While a traditional fuel-injected small-block Chevy V8 had the distributor at the rear of the engine block, the LT1 featured a new type of optical sensor placed on the front of the engine.

What was the year of the corvette transistor ignition?

T.I Specialty offers original and reproduction transistor ignition components for Corvettes produced in the years 1964, 1965, 1966, 1967, 1968, 1969, 1970, 1971. The General Motors (Chevrolet Division) designation for the transistor ignition was option code K66.

What’s the problem with the Chevy LT1 V8?

This engine featured a new distributor design called Optispark that was plagued with issues. If you own an LT1 car, here’s what to watch for and what to do when that Opti fails. Source | Rich Niewiroski Jr. The original small-block Chevy (SBC) V8 was built for decades, spanning from the mid-1950s through the 1990s.

What was the horsepower of a 1971 Corvette?

But those powerplants are of little interest to the Corvette purist, the man who remembers the soul and vitality of the high-winding fuel-injected 283 when it was the only street engine in the country that put out one horsepower per cubic inch. Today’s equivalent is the LT1 — a solid-lifter 350 rated at 330-hp.

What was the Research Octane Number on a 1971 Corvette?

In addition to the Federally sanctioned mandates on reducing exhaust emission outputs, Edward Cole (who was now president of General Motors) had decreed that all 1971 GM cars would be capable of running on fuel with a Research Octane Number (RON) no higher than 91 Octane.

What kind of lights did a 1971 Corvette have?

However, most 1971 Corvettes came equipped with clear lenses and amber bulbs, which was a carry-over from the 1970 model year.