What kind of case does a Ford transfer case use?

Available in either mechanical or electronic shift versions. The electronic shift version utilizes a worm gear driven mechanism. The two piece, magnesium case is visually similar to the BW1345, but with careful examination of the ribs cast into the case can help distinguish the two.

What kind of transfer case does Ford bw4411 have?

Ford BW4411: The BW4411 transfer case has a 28 Spline Input, front cup yoke, rear circular flange, no speedometer hole, no front and rear sensor hole and no rear sensor. Matched with 5R55S transmission. Single speed.

Where to find model number on transfer case?

Each Transfer Case is unique and specific to the vehicle. Please locate the identification tag on your transfer case and write down the Model & Assembly Numbers. These numbers are critical in determining the exact transfer case for your vehicle The NP208 is an honest, lightweight, chain driven transfer case.

What kind of transfer case does a Ford Broncos have?

Ford F-Series pickups and Broncos from 1987 through 1997 Identification: Metal tag stamped with “1356” located on transfer case, typically on the backside. Magnesium, ribbed, two piece transfer case (two part casting bolted together in the center). Contact TNT Transfer Case for the right transfer case for your vehicle.

Are there any problems with the Ford Explorer transfer case?

Ford Explorer owners have reported 95 problems related to transfer case (under the power train category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Ford Explorer based on all problems reported for the Explorer.

Are there any problems with the transfer case?

No signs of fluid leaks from transfer case or transmission. Transfer case is gumming up and tearing up my pto and causing grinding while accelerating. Spoke to my mechanic and he said that Ford is aware of the problem but has yet to issue a recall or extended warranty on issue.

Can a bad transfer case output shaft seal fail?

Over time the transfer case output shaft seal can fail, and when it does, will display a few symptoms that will alert the driver that a problem with this system exists. Noted below are a few of the common side effects of a damaged transfer case output shaft seal that should be replaced. 1. Difficulty shifting gears

Which is the best transfer case for HD trucks?

Contact TNT Transfer Case for the right transfer case for your vehicle. Basically the same case, the NP 271 has a manual shift and the NP 273 is electronically shifted; found in Ford HD trucks. NP271 & NP273. New Process Gear Two speeds:High: 1:1, Low: 2.72:1. Aluminum (magnesium) case. Front output. Chain Drive, fixed rear spoke.

What kind of transfer case does a Ford truck have?

Ford Transfer Case Applications: 1989-1996 (Electric shift) rear circular flange fr 1989-1996 (Manual shift) rear circular flange, fro 1987-1989 (Electric shift) front and rear fixed yo 1987-1989 (Manual shift) fixed front and rear yoke 1987-1989 (Manual shift) fixed front yoke rear cir

Why do you want a Ford 208 transfer case?

Why you want it: The 208 is lightweight, the chain- drive operates quieter, and it is shift-on-the-fly. Two additional perks are that the case is inexpensive and easy to find.

When was the Ford Bronco transfer case made?

It was used in early Broncos from 1966 until 1977 and it was used in some Ford pickups. It is drivers drop and it was available with a couple different low range ratios. Why you want it: Early Bronco versions have a strong housing, are small and lightweight, and can handle a fair amount of torque.

When was the Dana 20 transfer case made?

The Ford Dana 20 transfer case is gear driven with a cast iron case. It was used in early Broncos from 1966 until 1977 and it was used in some Ford pickups. It is drivers drop and it was available with a couple different low range ratios.

What kind of case does a Ford transfer case use?