What kind of car does the water pump puller remover fit?
What kind of car does the water pump puller remover fit?
Fits: Ford Escape 2001–2012, Ford Fusion 2006–2012, Ford Taurus 2001–2005, Lincoln MKZ 2007–2012, Mercury Mariner/Milan 2006–2011, Mercury Sable 2001–2005. Rugged, all metal construction ensures this versatile tool set will deliver reliable long-term service.
How long does it take to remove water pump pulley?
I have a 2008 Mercury Milan and this tool came with everything to take off and put on the the water pump pulley (the pulley above the pump and turned by the cam). Took just over two hours to do the whole job and taking the pulley off and putting it back on was one of the easiest tasks to do with this tool.
What is the OTC water pump pulley remover?
Video Player is loading. This is a modal window. OTC’s 7483A Water Pump Puller Remover/Installer helps remove and install water pump pulleys faster and easier on specific Ford, Lincoln and Mercury 3.0L DOHC V6 engines.
Where is the Waterpump on a Ford Escape?
I am stymied, however, by the seal behind the cam pulley at the rear of engne, which runs the waterpump. This pulley is evidently pressed into place, or can be pulled into place using the screw thread in the center of the cam at the same end of the shaft.
What kind of pulley to remove water pump?
Helps remove and install water pump pulleys faster and easier on specific Ford, Lincoln and Mercury 3.0L DOHC engines. The puller works on the below vehicles with a Ford 3.0 DOHC engine:
What kind of pulley does Ford 3.0 DOHC engine use?
The puller works on the below vehicles with a Ford 3.0 DOHC engine: This product can expose you to chemicals including CHROMIUM HEXAVALENT, which is known to the State of California to cause cancer, and CHROMIUM HEXAVALENT, which is known to the State of California to cause birth defects or other reproductive harm.
I am stymied, however, by the seal behind the cam pulley at the rear of engne, which runs the waterpump. This pulley is evidently pressed into place, or can be pulled into place using the screw thread in the center of the cam at the same end of the shaft.
How does the pulley work on a Ford Escape?
This pulley is evidently pressed into place, or can be pulled into place using the screw thread in the center of the cam at the same end of the shaft. I have not found any reference as to how anyone has successfully removed this outside the dealers.
