Common questions

What kind of alternator does a 2004 Chevy Silverado have?

What kind of alternator does a 2004 Chevy Silverado have?

I am trying to order an engine belt, tension pulley & idler pulley from RockAuto.com for my 2004 Silverado, extended cab Z71 offroad with 5300 engine. It has two listings for the parts, one for a 105 Amp alternator & different parts for a 145 Amp.

What is the alternator code for a GM Rolls Royce?

Click to expand… the standard alternator is the K68 105Amps .. then the optional for optional equipment is KG8 130amps. the code for 140 amp is KG9 . GM does not have generators in their vehicles but if it was a 1961 rolls Royce like I worked on today now that has a generator .

What to do if your alternator goes bad?

Find an old school auto electric shop close to you. Talk to the manager. They can usually rebuild your alternator with upgraded parts to a lot higher output cheaper than paying for a parts store rebuilt unit. The cookie cutter rebuilt units from the parts stores are low quality high volume units with a high failure rate.

Is the 47 alternator a generator or an alternator?

The 47 is not on the list I have but the K68 is, but it is listed as a Generator, not an Alternator.I’ll tr to post that list that I have. Click to expand… the standard alternator is the K68 105Amps .. then the optional for optional equipment is KG8 130amps. the code for 140 amp is KG9 .

I am trying to order an engine belt, tension pulley & idler pulley from RockAuto.com for my 2004 Silverado, extended cab Z71 offroad with 5300 engine. It has two listings for the parts, one for a 105 Amp alternator & different parts for a 145 Amp.

What’s the best way to replace an alternator?

Ensure all the bolt and/or nut threads are started and tighten them evenly. On some vehicles, the electrical connections will need to be installed first before permanently tightening the alternator for access reasons. Place the drive belt in position and ‘rotate’ the belt tensioner so the belt can be installed.

What happens if you leave your alternator alone?

Your alternator supplies your car’s battery and auxiliary systems with electrical current, and a failed alternator left alone will eventually lead you with a dead battery, or a dead car on the side of the road. Keep reading to learn the signs of a damaged alternator and find out the general steps required for a DIY alternator replacement.

Can a manual tensioner be used to replace an alternator?

The belt tensioner will only travel (swing) so far which can make installing the belt difficult. Never pry or force the belt onto the pulley. Vehicles with a manual tensioner or the belt tightens with the alternator, there should about ½ inch of deflection in the belt between the pulleys with the greatest distance between them. 7

Ensure all the bolt and/or nut threads are started and tighten them evenly. On some vehicles, the electrical connections will need to be installed first before permanently tightening the alternator for access reasons. Place the drive belt in position and ‘rotate’ the belt tensioner so the belt can be installed.

The belt tensioner will only travel (swing) so far which can make installing the belt difficult. Never pry or force the belt onto the pulley. Vehicles with a manual tensioner or the belt tightens with the alternator, there should about ½ inch of deflection in the belt between the pulleys with the greatest distance between them. 7

Why is my alternator not working in my car?

Keep in mind that many failures in the charging system can also be the wiring between the alternator and the battery, but it’s best to always start with the alternator. Because the alternator supplies current to the vehicle’s electrical systems, this is where you’ll notice most that something is amiss.

What kind of door actuator does Chevy Silverado have?

This 2004 Chevrolet Silverado came in with a faulty passenger side blend door actuator. In the last post I got you to this point. If you have not yet read that post please click here.

Where is the AC on a 2004 Silverado?

2004 Silverado AC blows hot on passenger side and regular on driver side. I just changed the battery, started the truck 2004 Silverado AC blows hot on passenger side..driver side… The drivers side of the air blows hot and the passenger side cold when the ac is on.

What are the fuses on a 2004 Chevy Silverado?

Repair Topics > Fuses > Chevrolet > 2004 Chevrolet Silverado… MBEC 1 50A SEAT CB. RT DOOR CB LBEC 2 50A LOCKS Fuse. DDM Fuse, PDM Fuse, ECC Fuse, AUX PWR 2 Fuse IGN A 40A Ignition Switch RUN. START. RUN/START/ACCY LBEC 1 50A FLASH Fuse, TBC 2A Fuse. TBC 2B Fuse.

How do you remove the belt on a Chevy Silverado?

Belt noise begins when the spring weakens or the pulley bearing begins to wobble. The engine crank pulley drives both belts. To remove the A/C belt, the accessory belt must first be loosened and slipped off the engine crank pulley.

How to replace alternator belt if air conditioner is broken?

How to replace alternator belt if the air conditioner is broken, you can use a short serpentine belt without air conditioning. How to replace alternator belt if the air conditioner is broken, you can use a short serpentine belt without air conditioning. Skip navigation Sign in Search Loading… Close This video is unavailable. Watch later Share

Can you replace tensioner in Chevy Silverado GMT800?

With basic tools and little time, you can replace the tensioner in your Silverado quickly in the comfort of your own garage. This article applies to the Chevrolet Silverado GMT800 (1999-2006).

Do you need to replace the alternator on a Chevy Silverado?

The alternator is charging the battery that allows them to keep running. So if you need to replace your alternator, keep reading as this article will help you through the process. This article applies to the Chevrolet Silverado GMT800 (1999-2006).

Belt noise begins when the spring weakens or the pulley bearing begins to wobble. The engine crank pulley drives both belts. To remove the A/C belt, the accessory belt must first be loosened and slipped off the engine crank pulley.

With basic tools and little time, you can replace the tensioner in your Silverado quickly in the comfort of your own garage. This article applies to the Chevrolet Silverado GMT800 (1999-2006).

Can a bad a / C belt tensioner be replaced?

Both noises point to a bad A/C belt tensioner. With basic tools and little time, you can replace the tensioner in your Silverado quickly in the comfort of your own garage. This article applies to the Chevrolet Silverado GMT800 (1999-2006).

How to find out which alternator I have?

It has two listings for the parts, one for a 105 Amp alternator & different parts for a 145 Amp. How do I find out which one I have? I have checked the entire owners manual and the code inside the glovebox ( which is just a few dozen 4 digit numbers) I checked the alternator itself but could not find any type of ID plate.

Author Image
Ruth Doyle