What is the fuse box on a Chevy Blazer?

A/C Compressor Relay, Cluster Chime Module, DRL Relay Coil, Four-Wheel-Drive Indicator Lamp, DRL Module, Rear Defog Timer, Transfer Case Control Module Ignition, SIR Redundant Ignition \ RKE Ignition, fuel Sender

When is the fuel pump relay turned on?

The fuel pump relay is activated whenever the ignition is turned on. A fuel pump relay functions primarily to maintain a consistent voltage supply to the fuel pump. The ignition or powertrain control module (PCM) usually controls the fuel pump relay.

Is the fuel pump relay controlled by the PCM?

Consequently, the fuel pump relay is usually controlled by, the ignition or powertrain control module (PCM). As a result, when switched on, the fuel pump relay; will provide current to the fuel pump, so that it may function. Therefore, any faults with it, can cause fuel pump issues.

What should I do if my fuel pump is not working?

Use Jumper wires to supply 12v power to terminals 86 and 85. Next, use a test light on terminals 87 and 30, to see if you have power. Finally, if the test light goes on the the problem lies somewhere else. Fuel Pump Circuit Breaker Reset

Where is the fuel pump relay on a car?

First, make sure that you have enough light and room to work. Then, open your vehicle’s hood and find the fuse panel. The majority of vehicles made today have the fuel pump relay located near here, and the fuel pump relay should look like a small plastic box with four to five electrical terminals.

Where are the fuse panels on a Chevy Blazer?

Here you will find fuse box diagrams of Chevrolet Blazer 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004 and 2005, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.

What is the average rating of a fuel pump relay?

Average rating from 198 customers who received a Car is stalling Inspection. The fuel pump relay is an electronic component that is found on virtually all vehicles equipped with an internal combustion engine.

Why does my fuel pump make a noise?

This noise is the solenoid inside the relay pulling it shut to connect the two posts together. If your meter does not show continuity from the fuel pump pin and the battery pin, or if you do not hear a clicking from the fuel pump relay, you need to replace your fuel pump relay.

Where are the fuse panels on a Chevy Express?

Here you will find fuse box diagrams of Chevrolet Express 1996, 1997, 1998, 1999, 2000, 2001 and 2002, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.

What kind of Fuse is in Oldsmobile Bravada?

Oldsmobile Bravada (1990-1994). The wiring circuits in the vehicle are protected from short circuits by fuses. This greatly reduces the chance of damage caused by electrical problems. To check a fuse, look at the silver-colored band inside the fuse.

What to do when Your Fuse goes out on your car?

To check a fuse, look at the silver-colored band inside the fuse. If the band is broken or melted, replace the fuse. Be sure to replace a bad fuse with a new one of the identical size and rating. Fuses of the same amperage can be temporarily borrowed from another fuse location if a fuse goes out.

Where are the fuel pump and AC relays located?

The AC relay is located in the same under-hood fuse/relay box the fuel pump relay is in (see illustration above). Locate the fuel pump and AC compressor relays in the under-hood fuse and relay box. Swap the relays .

How can I tell if my fuel pump relay is defective?

It’ll also show you how to bench test the fuel pump relay in a step-by-step way to find out if it’s defective or not. Contents of this tutorial: Before You Start Your Fuel Pump Relay Diagnostic. TEST 1: Swapping Out The Fuel Pump Relay. TEST 2: Making Sure The Fuel Pump Relay Has Power. TEST 3: Bypassing The Fuel Pump Relay.

What should fuel pressure be if fuel pump is not activating?

If the fuel pump relay IS NOT activating the fuel pump, the fuel pressure test gauge will register 0 PSI when cranking the engine. If the fuel pump relay is activating the fuel pump, then it’ll register about 56-62 PSI even if the engine does not start. Any fuel pressure below 50 PSI and the engine will NOT start.

When was the second generation Chevy Blazer Made?

In this article, we consider the second-generation Chevrolet Blazer, produced from 1995 to 2005.

What are the Illuminations on a Chevy Blazer?

Cluster Illumination, Radio Illumination, Heater Lamp, Four-Wheel-Drive Illumination, Chime Module, Fog Lamp Illumination, Rear Wiper Switch, Rear Defog Switch Illumination, Liftglass Release Switch Illumination, Overhead Console Illumination

Why does my Honda Blazer not start up?

Took it for a 10 mile drive, parked the car, went shopping, when I came out the Blazer started right up. Drove it home and parked it. Tommorrow will be the big test, if it starts up, and I do think it will, all my recent starting problems were due to a bad distributor rotor.

Why does my S10 Blazer have no spark?

I found that I had “no spark” and that I had 60 psi of fuel pressure present and holding. So that isolated my problem down to the electrical ignition system. My Distributor was replace about a 2 years ago. The Distributor Cap, Rotor, Spark Plug Wires, and Spark Plugs were replaced about 3 months ago.

How can I tell if my blazer has a spark or not?

I pulled the fuse, it looked like it was the factory original. Looking at the contacts in the fuse box for the fuse, the contacts on one side are shiney, while on the other side sort of a dark dull brass look, obvious color difference. So I installed a new fuse.

What should fuel pressure be when no Buzz?

Fuel pressure is typically in the 35 to 45 psi range. If your Anti-Theft light is flashing; the anti-theft system is disabling the fuel pump to prevent the engine from starting. Bad fuel pump (Pump should run for a few seconds when ignition key is turned to start, no buzz means no fuel delivery to the engine).

What causes the fuel pump to not start?

The fuel pump is running and delivering normal pressure to the engine But, with all that working your engine still will not start. So, the most likely cause, is that the fuel injectors are probably not opening. The (PCM) uses the trigger signal from the crankshaft position sensor; and/or camshaft position sensor to pulse the injectors.

Where is the fuse for the fuel injector located?

Blown injector circuit fuse Bad fuel injector power relay A fault in the wiring harness to the injectors So, the injector fuse and relay are usually located; in the relay box or power distribution center in the engine compartment. Fuses are used to protect various electrical circuits, while supplying power to components.

Is there a Chevy Blazer that will not start?

And any body’s help is appreciated, it’s a 97 chevy blazer that will not start. Good spark, fuel, and compression. Backfires out intake only when I stop cranking.

How can I tell if my fuel pump relay is faulty?

2. Engine does not start. Another symptom of a faulty fuel pump relay is an engine that does not start. If the fuel pump relay fails the fuel pump will be left without power. The engine may still crank when the key is turned, however it will not be able to start due to lack of fuel.

How to search on the Chevy Blazer Forum?

Both the site search feature and the Custom Google search provided below can be used to search the forum for problems you may be experiencing. Check out the ‘Search Guidelines’ post for tips & techniques on performing fast and effective searches. Are you new to Blazer Forum? WELCOME! Check in, tell us about yourself and your ride. TH350 w/np203.

What are the rules for the Blazer Forum?

BlazerForum Rules – please read and follow the rules of the forum. “I didn’t know…” is no excuse. There is a wealth of information available on the site. Please search before posting.

When did the first Chevy Trailblazer come out?

In this article, we consider the first-generation Chevrolet TrailBlazer, produced from 2002 to 2009.

What to do if your GM fan won’t defrost?

See if this fixes the problem. Many of GM’s AC control heads have a built in reset feature that when power is removed and then applied it will go through a cycle that activates all the vent doors and mode doors. It’s worth a try.

Can a climate control fan only blow defrost?

SilveradoSierra.com • Fan Only Blows Defrost, Won’t Change To Floor Or Vent. : Climate Control Fan Only Blows Defrost, Won’t Change To Floor Or Vent.

Is the Astro fan only blows defrost?

Re: Fan Only Blows Defrost, Won’t Change To Floor Or Vent. Yea the problem with them astro’s is the way the damn motor is crammed into the dog house with the heat it destroys the hard plastic vacume line . I have had 5 of them and every one had this problem until you change them out with rubber lines .

What to do if your truck fan won’t change?

When you reattach the battery and crank the truck dont touch anything for five minutes. Then shut the truck off, crank it and see if its fixed. Not touching anything lets it go through its relearn process. Re: Fan Only Blows Defrost, Won’t Change To Floor Or Vent. I tried taking the neg off the battery but it didn’t fix it.