What is the fuel pressure reset code on a Malibu?

Associates of Applied Scien… Code P228D. P228D Reset code. 2013 Malibu with 2.5. Sounds Sounds like the fuel pressure regulator. Intake is off to the throttle body.

What to do if your check engine light says p0011?

Check to see if there are any other codes along with P0011 and clear your Check Engine Light with FIXD. Check the engine oil level and condition. If it’s low, adjust to spec and test drive to see if the concern is resolved. If it’s dirty, change the oil and filter and test drive to see if the concern is resolved.

What does it mean when battery saver active on Chevy Malibu?

If you are getting a “ battery saver active ” message, it means that your Malibu’s electrical system voltage has dropped to a critical level (less than 11.7 volts). Typical electrical systems run at 13+ volts with the engine running. The battery should also be over 12 volts even with the vehicle sitting.

What are the symptoms of the code p0011?

What Are The Symptoms Of Code P0011? 1 Check Engine Light 2 The hard start of the engine 3 Rough running engine 4 Stalling 5 Rattling/Knocking from engine 6 Decreased fuel economy 7 Failed emissions test

What kind of problems can cause a p228d code?

Common Problems That Trigger the P228D Code 1 High pressure fuel pump failure 2 Powertrain Control Module (PCM) failure 3 Restriction in the fuel system 4 Wiring issue 5 Worn or damaged camshaft

What causes the p0089 OBD-II trouble code?

What causes the P0089 code? 1 Failed fuel pressure regulator 2 Clogged fuel filter or screen 3 Restricted fuel lines 4 Fuel pump output not meeting specifications

How is the p228d code set on a powertrain control module?

The Powertrain Control Module ( PCM) monitors the fuel pressure. The code is set when the PCM detects the fuel pressure out of factory specifications. Need more information on how to fix the P228D code?

What happens when p228d fuel pressure regulator exceeds control limits?

If actual fuel pressure regulator 1 control circuit voltage exceeds a certain parameter (as computed by the PCM), and actual fuel pressure is not within specifications, a P228D will be stored and a malfunction indicator lamp (MIL) may be illuminated. A typical fuel pressure regulator: What is the severity of this DTC?