What is the error code for a dial-up connection?

What is the error code for a dial-up connection?

The Service Type RADIUS attribute for this user is neither Framed nor Callback Framed. 797. A connection to the remote computer could not be established because the modem was not found or was busy. For further assistance, click More Info or search Help and Support Center for this error number.

How to find the fault code for a BMW?

BMW Fault Code Lookup Enter a BMW fault code (P or hex), complete the Captcha, and click “Search” P-Codes will start with a P and are usually generated by generic scanners. Example: P1055

What is the error code for the port is not connected?

The port is not connected. The event is invalid. The device does not exist. The device type does not exist. The buffer is invalid. The route is not available. The route is not allocated. Invalid compression specified.

What is the error code for no dial tone?

There is no dial tone. General error reported by device. Access denied because username and/or password is invalid on the domain. Hardware failure in port or attached device. A response keyname in the device .INF file is not in the expected format. The device response caused buffer overflow. The expanded command in the device .INF file is too long.

What are the common causes of code p1494?

What are the common causes of code P1494? Typical causes of P1494 could include the following- Damaged, burnt, shorted, disconnected, or corroded wiring in the LDP Switch Control Circuit, or in one or more control circuits of sensors that supply input information to the LDP/PCM.

What is code p1494 for leak detection pump?

Nonetheless, as stated before, code P1494 is less concerned with leaks in the EVAP system than it is with whether the Leak Detection Pump is working or not.

When does code p1494 set in Powertrain Control Module?

Note however that the above definitions all have the same basic meaning, which is that code P1494 sets when the PCM (Powertrain Control Module) has detected a malfunction in the LDP ( [EVAP] Leak Detection Pump) itself, as opposed to when a leak in the EVAP system is detected.