What is the ECU on a Deere 323d?
What is the ECU on a Deere 323d?
ECU 000651.05 These are all engine fuel injection system codes. Hydraulic oil filter is restricted. I believe most of these codes are from when I was testing the glow plug circuit. I had a lot of the wires disconnected and was turning the key on and off to get voltage readings.
What is the ECU code on a John Deere?
ECU 000097.04 ECU 000097.16 – Engine water trap full – Remove water from water trap. ECU 000100.01 – Engine oil pressure low – Check engine oil level. If the code returns, arrange for repair immediately through a John Deere dealer. ECU 000100.03 – Engine system – The problem with the voltage signal of the oil pressure in the engine.
What to do if you have a John Deere fault code?
Check the fuel filter, if the code reappears, then the John Deere dealer should repair the repair as soon as possible. ECU 001569.31 Fuel – reduced power rating
Is the Deere 323d tracked skid steer running great?
There are some old codes stored that I don’t think are relevant but there is one code that has come up recently which is ECU 920.05, Alarm output out of range low. The machine has relatively low hours and except for the starting issue, it runs great. I have: 1. Replaced all the rubber fuel lines and tested for leaks. 2.
When to start a Deere 323d tracked skid steer?
Any time of the day, if it hasn’t been running for a while, 8 hours or so, It has a hard time starting. It cranks over just fine. Cranks really fast and you can tell it’s trying to start. It blows a little black smoke while cranking then after 20 -30 seconds it will start.
What’s the fuel pressure on a Deere 323d?
As soon as I cranked it the fuel pressure went to 30 psi almost immediately but it had the same hard start condition. When I shut it down, the fuel pressure slowly dropped to 0. It took about 3-5 minutes. I had the fuel return line disconnected during this time and no fuel came out of it while the pressure was dropping.
ECU 000651.05 These are all engine fuel injection system codes. Hydraulic oil filter is restricted. I believe most of these codes are from when I was testing the glow plug circuit. I had a lot of the wires disconnected and was turning the key on and off to get voltage readings.
ECU 000097.04 ECU 000097.16 – Engine water trap full – Remove water from water trap. ECU 000100.01 – Engine oil pressure low – Check engine oil level. If the code returns, arrange for repair immediately through a John Deere dealer. ECU 000100.03 – Engine system – The problem with the voltage signal of the oil pressure in the engine.
What is the trouble code on a John Deere?
Diagnostic trouble codes of the engine control unit (ECU) Diagnostic Trouble Code – Display – Decision ECU 000097.03 – Engine system – The problem with the signal Water in the fuel. Arrange repair as soon as possible through a John Deere dealer. ECU 000097.04 ECU 000097.16 – Engine water trap full – Remove water from water trap.
How many hours does a John Deere 323d have?
It’s a 2013 that’s sitting in a non JD dealer on consignment has about 600 hours on it, tracks are about 30% ($$$$$) and it’s 36K $can. Still back and forth between wheel machine/aftermarket tracks and a CTL.