What is KK Ultra?
What is KK Ultra?
KK ULTRA bits are the pioneers of modern bits because they have been developed on the basis of scientific research. They achieve their unique, precise effect through the special 45° angle of the middle link. This anatomical adaptation noticeably optimises the effect compared to conventional double jointed bits.
Are Loose Ring Snaffles good?
What’s it good for? Loose ring bits help the horse to position the bit where they like it unlike fixed bits such as the eggbutt or hanging cheek snaffle. The looser the bit the more it encourages a horse to come off the forehand and work more from behind.
What is a loose ring snaffle used for?
Loose Ring Snaffles The loose ring snaffle is a commonly used bit for breaking and training. They can have a simple curved or jointed mouth piece and the rings are attached by a simple loop at the end of the mouth piece.
How should a loose ring snaffle fit?
A full cheek snaffle, Pelham or elevator bit should fit snugly next to the horse’s cheek, but should not squeeze or pinch. For a loose ring snaffle or any bit with moveable rings, make sure that the horse’s lips completely clear the bit ring holes by 1/8 inch on each side.
Which way does Sprenger bit go?
All Sprenger bits that are marked with an arrow at the side of the mouthpiece have to be positioned correctly in the horse’s mouth. In order to ensure Optimum effectiveness the arrow has to point forwards on the left hand side.
What is the difference between a loose ring and D-ring snaffle?
The most direct line of pressure comes from the 2 fixed ring snaffles; the D-Ring and Egg Butt. These fixed ring snaffles make it slightly easier for a colt to learn to give to the pressure of the pull than a loose ring snaffle does. Loose ring snaffles have a smaller area of pressure when a direct rein pull is made.
Do loose ring bits pinch?
The ring will also rotate slightly before the bit mouthpiece adds pressure to the mouth, thus allowing it to give more signal than a more fixed bit. Disadvantages: the loose ring may pinch the corners of the lips as it rotates, causing pain to the horse. This is especially a problem if the bit mouthpiece is too small.
What is the difference between a loose ring and D ring snaffle?
What is the difference between Eggbutt and loose ring snaffle?
Loose ring – this slides through the mouthpiece, allowing easy movement. It encourages a relaxed jaw but may pinch the sides of the mouth, necessitating a bit guard. Eggbutt – this type of cheek keeps the bit stable and prevents rotation. It doesn’t pinch the lips so is tolerated better by some horses.
How are Sprenger bits measured?
Put your index and middle finger together and insert them in the horse’s mouth at the point where the bit usually lies. Pressure on both fingers (small gap between the upper and lower jawbone) requires a thinner mouthpiece (14 – 16 mm).
What does a double jointed snaffle do?
The double-jointed snaffle has an additional center piece which is thought to decrease the tenting effect on the horse’s soft palate as well as decrease the pinching of the tongue while delivering a more precise pressure to the bars of the mouth.
