What happens when you change the ignition switch on a Dodge Ram?

When they do fail, the electrical current will not reach some or all of the truck’s components, which can cause the radio to stop working, the blower motor to stop functioning, and the engine to quit starting. Luckily, replacing the ignition switch in your Dodge Ram is a relatively simple process.

How do you remove the rear ignition switch?

Remove the tilt lever assembly screws. Pull back on the red tab of the rear ignition switch connector, and unplug it from the dash wire harness. Then pull back on the tab of the front switch connector, and unplug it to release the ignition switch from the lock cylinder.

Do you have to take steering wheel out to replace ignition switch?

Take the steering wheel out if it’s in the way. In some vehicles, you may be able to replace the ignition switch without removing the steering wheel. However, if you’re unable to get access to the top of the ignition switch with all the interior trim pieces removed, the steering wheel may need to come out.

What to do if your key is stuck in the ignition switch?

The key may be stuck in the ignition switch, but that shouldn’t stop you from turning it. If you don’t have a key, you will need to force the module to turn using a flathead screwdriver. Press the release pin inside the hole on the ignition module with a screwdriver.

How do you replace the ignition switch on a Dodge Ram?

Use a T25 Torx screwdriver to remove one screw underneath the tilt lever mechanism. Then, use the T20 screwdriver to remove one screw underneath the ignition switch. Figure 6. Remove the tilt lever assembly screws. Pull back on the red tab of the rear ignition switch connector, and unplug it from the dash wire harness.

Can a rusty ignition switch keep a Ram 1500 from starting?

The last thing you want is for your Ram 1500 to be stuck on a jobsite, unable to start. When your ignition switch becomes rusty or faulty, it no longer transmits a signal to turn your truck on. Instead of being stuck with this problem, consider a new ignition switch for Dodge Ram 1500, affordable and available at AutoZone.

Is the Dodge Ram 5500 ignition switch compatible?

Register a free business account (X81) Ignition Switch Module This New Mopar OEM factory condition (X81) Ignition Switch Module is compatible with the following vehicles: 2017-2019 Dodge RAM 1500 (Old Body) 2013 – 2017 Dodge RAM 2500 2013 – 2017 Dodge RAM 3500 2013 – 2017 Dodge RAM 4500 2013 – 2017 Dodge RAM 5500 Manufacturers Part #: 68271986AB

How do you replace an ignition switch on a car?

Installing a Replacement Squeeze the release pin on the ignition switch so it’s flush with the side. The same release pin that stopped the switch from coming out now needs to be pressed in so you can slide the switch into place inside the ignition module. Slide the ignition switch into its hole.

Is it possible to rebuild an ignition switch?

Only some dealerships will rebuild an ignition switch and they often can’t for all vehicles, so rebuilding yours may not be an option. In that case, you will need to get a new switch from a manufacturer specific dealership that will also provide you with new ignition keys to match.

Can a worn key cause an ignition switch to go bad?

Before spending time and money to replace the ignition switch, a thorough diagnosis should be performed. Some of the symptoms above can be caused by a worn key. Also, the term “ignition switch” commonly refers to the full ignition assembly, which includes the ignition lock cylinder and the ignition switch.

Is the ignition switch part of the ignition assembly?

Also, the term “ignition switch” commonly refers to the full ignition assembly, which includes the ignition lock cylinder and the ignition switch. Depending on the type of failure, these parts can be replaced individually or as a unit.