What happens if I Disconnect my OnStar service?

Even after your service is cancelled, OnStar can continue to collect data from your vehicle for its marketing and other purposes. To prevent OnStar from having access to your driving information, continue with this method to learn how to physically disconnect the OnStar module.

How do you remove the OnStar module from a vehicle?

1. Remove Onstar Module from vehicle. 2. Remove the 6 T10 screws from the bottom of the Onstar Module. 3. Pull up on the main board to separate it from the antenna board. 4. Remove the Male/Male connector that connects the main board to the antenna board. 5. Drop the main board back in without the Male/Male connector and reinstall the screws. 6.

How do you unplug an OnStar silver box?

Locate the three cable connectors on the bottom of the silver box. To unplug a connector, grip its base with two fingers and press them inward, and then pull the plug straight out. Repeat until there are no cables connected to the silver box.

Where are the screws to deactivate OnStar?

If your vehicle does not have a cargo net in the trunk, the four screws you need to remove should be located in the corners of your trunk. After removing the screws, pull the sill plate up to lift it out of the trunk. Set it and the screws aside in a safe spot while you continue working.

How to disable OnStar on my Chevy Silverado?

Onstar disable solved. Sign up for FREE! Become a GM-Trucks.com Member Today! In 20 seconds you can become part of the worlds largest and oldest community discussing General Motors, Chevrolet and GMC branded pickups, crossovers, and SUVs.

Where is the OnStar antenna on a Chevy Silverado?

OnStar is standard equipment on many GM vehicles including Chevy Silverados. This can be troublesome as there is a separate charge to maintain the OnStar service, and many customers choose not to use it. These customers may opt to remove the unsightly “fin” antenna that sits on the roof.

How do you remove an OnStar antenna from a car?

Remove the nut and any screws holding the antenna in place. Pull up the antenna from the roof of the car. Some plugs will come up with it, so unplug them to remove the fin completely. Re-attach the headliner and replace all the screws to finish the job. After removing the OnStar antenna, there will be a small hole in the roof of your truck.

What do you need to know about OnStar?

OnStar is a subscription-based service that provides remote vehicle diagnostics, communications, security, and other features for vehicles. The company is a subsidiary of General Motors, and is popular for capabilities like turn-by-turn navigation, hands-free calling, and as a surveillance device when your car or truck is left unattended.

How can I disable the OnStar equipment on a 2020 Sierra?

How can I disable the Onstar equipment on a 2020 Sierra? I called immediately after picking the truck up and cancelled all trial services, the green light went off. But I want to physically disconnect the system.

Is there a way to disable the OnStar module?

As soon as you can see and access the OnStar module box, you can stop pulling the panel out of place. Step 6: Remove the three connectors on the OnStar module box. Press the tab down on the cord end that connects with the module box port and pull the connector right out.

What’s the best way to unplug an OnStar system?

To unplug a connector, grip its base with two fingers and press them inward, and then pull the plug straight out. Repeat until there are no cables connected to the silver box. These three cables provide power to the system and allow the system to communicate with OnStar.

Where is the OnStar module located in a car?

In most vehicles, the OnStar module is mounted to the back of either the right or left rear wheel well, both of which can be accessed through the trunk. In other vehicles, the module may be found behind the glove box or (in some larger trucks) under a wide plastic panel below the stereo.

What happens if I Disconnect my OnStar service?