What does the OBD-2 diagnostic code stand for?

OBD-II Diagnostic Trouble Codes are 4-digit, preceded by a letter: P for engine and transmission (powertrain), B for body, C for chassis, and U for network. The OBD-II specification provides for a standardized hardware interface—the female 16-pin (2×8) J1962 connector.

Where are OBD2 codes stored in a car?

Diagnostic trouble codes (or fault codes) are obd2 codes that are stored by the on-board computer diagnostic system. These are stored in response to a problem found in the car by the system. These OBD2 codes are stored when a sensor in the car reports a reading that is outside the normal/accepted range (Eg: fuel mixture too rich).

Is it safe to reset an OBD2 diagnostic trouble code?

Codes should be used in conjunction with the vehicle’s service manual to discover which systems, circuits or components should be tested to fully diagnose the fault with a car code reader or professional OBD2 software. Is it safe to reset an OBD2 Diagnostic Trouble Code?

Can a check engine light show an OBD2 code?

When the system identifies an issue, it turns on the check engine light and provides real-time data in addition to a standardized series of Diagnostic Trouble Codes (or DTCs). With a code reader or scanner, you can access one or more OBD2 codes that indicate the issues.

What are generic or global OBD II codes?

Generic or global OBD II Diagnostic Trouble Codes are common for any OBD II compliant vehicle, be it Domestic, Asian or European. These codes are sometimes called “P-codes” and typically begin with “P0” or “P2”.

What are the OBD codes?

The On-Board scanner is a pair of systems with no exceptions. These systems are known to use codes referred to as On-Board diagnostic codes (OBD) which is a combination of Codes to get precise and brief you on the state of the car engine fault status.

What is OBD trouble codes?

The diagnostic trouble code is the code your OBD generates to tell you something is wrong. Reading as a series of five letters and numbers, the DTC allows you to home in on the system that is not functioning properly. For example, if your vehicle’s OBD detects a leak in the evaporative emission system, you may see a P0442 code.

What does OBD II code p2646 mean?

What the P2646 code means. P2646 is an OBD-II generic code for the engine control module (ECM) detecting the ‘A’ rocker arm actuator control circuit for bank 1 has a performance problem or is stuck in the off position.