What does OBD I diagnostic code 88-95 mean?
What does OBD I diagnostic code 88-95 mean?
Full list of OBD I Diagnostic Trouble Codes for your ’88 – ’95 Chrysler. If your Check engine light is on you may have a serious problem. Scan your codes and follow the chart to determine what the code means. Some shops will scan your codes for free.
How to get the obd1-2 car code?
33 – A/C clutch relay circuit, open or short detected. 34 – Speed control servo solenoid, open or short detected. 35 – Radiator fan control relay circuit, open or short detected. 36 – Waste-gate solenoid, open or short detected.
What was the Check Engine Light code for 1990-92?
32 (1990-92, all but Turbo) computer didn’t see change in air/’fuel ratio when EGR activated – check valve, vacuum lines, and EGR electrical 33 Air conditioning clutch relay circuit open or shorted (may be in the wide-open-throttle cutoff circuit)
How to get the Check Engine code on a 1995 neon?
On some models (such as a 1995 Neon), when the check engine light goes on, you may be able to get the codes simply by putting in the key and moving it to the RUN position; the light will blink out the codes by itself. Please note that some codes are NOT included below, this is not a complete listing, but it IS very close to complete.
Full list of OBD I Diagnostic Trouble Codes for your ’88 – ’95 Chrysler. If your Check engine light is on you may have a serious problem. Scan your codes and follow the chart to determine what the code means. Some shops will scan your codes for free.
On some models (such as a 1995 Neon), when the check engine light goes on, you may be able to get the codes simply by putting in the key and moving it to the RUN position; the light will blink out the codes by itself. Please note that some codes are NOT included below, this is not a complete listing, but it IS very close to complete.
How to clear the OBD1 code on a Chrysler?
To clear codes disconnect the negative battery terminal for 30 seconds and reconnect. 11 – Camshaft signal or ignition signal, no reference signal during cranking. 12 – Memory to controller has been cleared within 50-100 engine starts.
