What does code EEC 61 diag 1 on a 2013 Freightliner?
What does code EEC 61 diag 1 on a 2013 Freightliner?
Fault code EEC 61 is telling the driver there is a problem with Aftertreatment system. Since this is a 2013, depending on the mileage, this truck is probably under Detroit warranty and I suggest taking it in for repair ASAP.
What is the Te code on a Freightliner?
Last eight on the vin are DHFE7693. Te code is EEC 61 Te readouts in order are: Diag 1 Fault 1 EEC 61 3363SPN Fail 3 Note: i just had aux LED lights in … read more We also have a 2012 Freightliner with the DD15, showing EEC 61. The rest of our code is: SPN 4356 Fail 5. Would like to know what it means. Thank you. … read more
What does fault code EEC 61 mean on a 2013 Ford Ranger?
Fault code EEC 61 is telling the driver there is a problem with Aftertreatment system. Since this is a 2013, depending on the mileage, this truck is probably under Detroit warranty and I suggest taking it in for repair ASAP. If ignored, the problem could get worse, or eventually derate the engine so bad your truck will only go 5mph.
When to use EEC 61 freigtliner Cascadia?
If your DEF got low, it will throw a EEC61, but you need to fill the DEF tank 1/2 full or more. After you drive awhile, after 3 key cycles that light should go off. IF THIS IS THE PROBLEM. If you do not fill it up, the Engine will Derate to 25%, then if you continue to drive, it will derate you to 5 miles per hour.
Fault code EEC 61 is telling the driver there is a problem with Aftertreatment system. Since this is a 2013, depending on the mileage, this truck is probably under Detroit warranty and I suggest taking it in for repair ASAP.
Is there a no crank no start truck?
Discussion in ‘ Freightliner Forum ‘ started by sixxjoe, May 19, 2013 . I have an 07 m2 with a no crank no start…I have power everywhere is should be…starter alt power block on the fender well but when I key up the truck I get a beep and no gauge sweep or codes.
Is there a no crank no start scanner?
I removed the starter tested it comes back fine, completely cleaned and sealed the fuse block outside great battery power but now I am lost. am a 1 man show for a small company and no scanners are available to me, so ideas without breaking the bank? bonous Thanks this. Every month 400 people find a job with the help of TruckersReport.
If your DEF got low, it will throw a EEC61, but you need to fill the DEF tank 1/2 full or more. After you drive awhile, after 3 key cycles that light should go off. IF THIS IS THE PROBLEM. If you do not fill it up, the Engine will Derate to 25%, then if you continue to drive, it will derate you to 5 miles per hour.