What does ABS code b1342 on Ford Explorer mean?

Hi, I got Ford Explorer XLS 2006, VIN: 1FMEU72E06UB24150, the computer showed up two errors C1285 Booster Solenoid Circuit Failure and B1342 ECU is failed. What does it mean and which parts are defect … read more I have a 2001 taurus with a/t, a/c, 3.0 dual overhead cams with abs code B1342. Do I need to replace the control modual?

What does b1342 mean on a Ford ECU?

The B1342 code means that the Electronic Control Unit (ECU) has failed, usually the code is combine with other issues or codes. Repair other problems before replacing the ECU What does this mean? Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors.

What does the OBD 2 fault code b1342 mean?

END OF SPECIAL NOTES. OBD II fault code B1342 is most commonly defined as “ECU (Electronic Control Unit) has failed”, or sometimes as “GEM (Generic Control Module) has failed”.

What does b1342 stand for on a Jaguar?

B1342 – Jaguar: “Internal ABS control module failure” B1342 – Ford: “ECU IS FAULTED”, or on some scanners, “ECU Failure”. Note that in the case of Ford products, this code can refer to almost any controller that is not concerned with engine/fuel/transmission management functions.

How much does it cost to repair a b1342 Ford engine?

The cost of diagnosing the B1342 FORD code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Note that in the case of Ford products, this code can refer to almost any controller that is not concerned with engine/fuel/transmission management functions. After proper recollection of that code, I remembered, it was a body code B1342. Which equals a antilock brake module failure.

What does the 1342 code in ABS mean?

The 1342 code is kind of like a death code that indicates the module itself is faulty, and usually isnt caused by a poor power or ground feed, especially since you were able to retrieve the code it indicated that the powers and grounds ARE in fact powering up the module. Though if you prefer you could load test the power…

Where is the b1342 fault code stored in the ABS module?

Also found a company that re-mans units and will send yours back to you if you send it in. Was Bosch the OE Supplier for Ford for these modules? Thanks! B1342 means there is a configuration error in the module you are scanning – in this case, since you selected ABS, the code is stored in your ABS module.

What does ABS code b1342 on Ford Explorer mean?