What do you need to know about Kohler automatic transfer switches?

3 SPEC YOUR JOB AT KOHLERPOWER.COM 4 STANDARD ATS SERVICE ENTRANCE ATS Bridging the gap between loss of utility and standby power is no small task. KOHLER ®automatic transfer switches (ATS) are designed to meet that challenge, distributing power to feed the critical loads of your facility.

Who are the engineers behind Kohler Power Systems?

Behind that power system is a team of dedicated Kohler engineers that focuses on every element – generator, transfer switch, switchgear and controller – to be sure the system you get is the system you need. You’ll know that your project is supported by an expert team, customized to your exact needs, brought in on budget and on time.

What to do if your Kohler engine is having problems?

Remember to follow all safety precautions before starting any work on your engine. If troubles persist after checking the possible causes listed or you are unable to identify the problem, call KOHLER Engines Customer Service at 1-800-544-2444 or contact your local KOHLER dealer.

Why do you need a Kohler automatic transfer switch?

KOHLER ® automatic transfer switches ATS) are designed to meet that challenge, distributing power to feed the critical loads of your facility. Every transfer switch needs a controller to ensure transfer of power from utility to generator and back again.

Can you transfer power from a generator to an ATS?

At that point the generator started but the transfer didn’t occur. I was able to manually switch to generator power and when the utility came back it transferred back correctly. Subsequent testing by manually cutting off the utility replicated the same situation: generator starts but no transfer.

How to disable a generator on a transfer switch?

Turn off the main circuit breakers of all transfer switch power sources and disable all generator sets as follows: (1) Move all generator set master controllerswitches totheOFFposition. (2) Disconnect power to all battery chargers. (3) Disconnect all battery cables, negative (–) leads first.

Why does my Gentek generator not transfer voltage?

When the generator is in Auto mode, you should have 12V+ on 194 to ground or the 0 wire. 23 will not have voltage as it’s just either grounded or ungrounded depending on the desired position of the switch. If you don’t have 12V+ on 194, you’ll have to get out to the gen and see if you have it at the terminal strip in the gen.