What did I do about the Freon leak in my Dodge Ram?
What did I do about the Freon leak in my Dodge Ram?
So we cleared the system and them sucked the system down and it held vacuum for 20 minutes. We checked every line, coupler, hose under the hood, no oil or sign of a leak. Filled it up and 4 days later and 10 miles most of the freon was gone. So I added dye to see if I could spot a leak that way.
Where is the refrigerant located on a Dodge Ram 2500?
This is the discharge hose that carries the hot refrigerant to the condenser that is located in front of the radiator where it dissipates the heat that is captured in the R-134A refrigerant. Remove the service port caps that are located either on the hoses or compressor, depending on the year of the Ram 2500.
Where is the dye leak on a Dodge Ram?
On the low side of the A/C system, the dye would have worked well, but on the high side, it escaped too “fast” from the leak area to leave the residue. The compressor has a handful of seals, including one under the output shaft (under the a/c coil pulley), and if leaking, could be difficult / impossible to see. One last thing to try.
How do you add Freon to a Dodge Ram?
Connect the hose that goes to the red gauge onto the D port. Install a can of freon onto the can tap that is connected to the center hose of the manifold gauge. Start the truck, turn on the A/C and read the A/C service gauges. It is not necessary to open the gauge valves.
What to do if your Dodge Ram has a leak?
When the air conditioner in your 2003 Dodge Ram 2500 starts blowing hot air, you likely have a freon leak. Recharging the freon in your AC system is an inexpensive and easy first step to restoring the cooling capacity of your A/C system. Most refrigerants include a leak sealer that will seal small leaks in addition to filling the R134a refrigerant.
Can you add Freon to a Dodge Ram 2500?
The A/C system in your Ram 2500 consists of a compressor that is belt-driven, an evaporator and freon. If there is a problem with your compressor or evaporator, adding freon will not restore cooling. How to add freon to your 2003 Dodge Ram 2500: hook up the can of refrigerant (likely r-134a) to the low pressure port.
What to do if your Dodge Ram runs out of refrigerant?
Start the truck, turn on the A/C and read the A/C service gauges. It is not necessary to open the gauge valves. If the A/C gauge readings are zero, the 134-A refrigerant has all leaked out and there is no refrigerant pressure inside of the A/C system to read.
Why is my Dodge Ram 2500 blowing hot air?
When the air conditioner in your 2003 Dodge Ram 2500 starts blowing hot air, you likely have a freon leak. Recharging the freon in your AC system is an inexpensive and easy first step to restoring the cooling capacity of your A/C system.
So we cleared the system and them sucked the system down and it held vacuum for 20 minutes. We checked every line, coupler, hose under the hood, no oil or sign of a leak. Filled it up and 4 days later and 10 miles most of the freon was gone. So I added dye to see if I could spot a leak that way.
On the low side of the A/C system, the dye would have worked well, but on the high side, it escaped too “fast” from the leak area to leave the residue. The compressor has a handful of seals, including one under the output shaft (under the a/c coil pulley), and if leaking, could be difficult / impossible to see. One last thing to try.
Where does the water come from in a Dodge Ram?
When the A/C in your Dodge Ram operates, water is produced and is supposed to drain out of the cooling system and truck cabin via the drain hose. If you notice a water leak puddling up the passenger’s side foot well, there are two minor issues at fault.
How often does my gas tank leak Freon?
Owned it 3 years it always had a slow leak about 1 can a year. However this year Im losing 80% of the freon in less that a week even if the car isnt driven. I took it to my friends work and evacuated the system, then pressurized it to 280 psi with nitrogen and let it sit for 20 minutes, no loss of pressure.
