Common questions

What causes hard shifting on a Chevy Impala?

What causes hard shifting on a Chevy Impala?

Some drivers never got a solution for the Impala’s hard shifting. However, some mechanics found that the cause was a failed transmission pressure control solenoid. To fix the problem, partial disassembly of the transmission was the only option. On average, this repair can cost around $1,000.

What are the most common problems with a Chevy Impala?

Chevy Impala: The Most Common Problems You Should Know About. 1 Gas cap problems. A car’s check engine light can come on for multiple reasons, some more severe than others. Many drivers of Impalas from every model 2 Faulty instrument panel gauges. 3 Jolting. 4 Shifter malfunction. 5 Bad transmission pressure control solenoid.

Why does my Chevy Impala jerk after acceleration?

To avoid the $450 repair charge, many drivers instead used a GPS to measure the car’s speed. Even in later years, many Impalas are reported to jerk after acceleration. Drivers reported that the engine would hesitate to speed up, then jolt forward as the shifter “caught up”.

How much does it cost to fix a Chevy Impala transmission?

To fix the problem, partial disassembly of the transmission was the only option. On average, this repair can cost around $1,000. However, since it wasn’t a life-threatening issue, many drivers opted not to get it fixed.

What kind of shift does a 2003 Impala do?

2003 Impala 3.4. Car jerks 4-6 small times when shifting from 1st to 2nd after warmed up. It only does the jerking when given just a little acceleration. When giving plenty of gas it shifts perfectly. It shifts fine at any speed when cold. Only when warm does it act up.

What’s the acceleration hesitation on my Impala 3.9?

My ’08 with 3.9 is at the dealer for the same thing, they’re having trouble finding what is wrong because there are “no codes”. Had to take the tech for a ride instead of paying for another injector flush that they already tried. Would love to get any additional info, like the alldata scoop.

What’s the throttle plate angle on an Impala?

Please discard Corporate Bulletin Number 06-07-30-023D (Section 07 – Transmission/Transaxle). Some customers may comment on a 1-2 shift shudder at light to moderate acceleration. Typically, the throttle plate angle parameter is 12-20% at time of condition with vehicle speed of approximately 24-40 km/h (15-25 mph).

What makes a car shift at any speed?

It only does the jerking when given just a little acceleration. When giving plenty of gas it shifts perfectly. It shifts fine at any speed when cold. Only when warm does it act up. I have new plugs and wires, front wheel bearings, cleaned MAF sensor, changed fuel filter and air filter.

Some drivers never got a solution for the Impala’s hard shifting. However, some mechanics found that the cause was a failed transmission pressure control solenoid. To fix the problem, partial disassembly of the transmission was the only option. On average, this repair can cost around $1,000.

Is the 2014 Chevy Impala a reliable car?

Extremely comfortable, reliable car with all of the bells and whistles. 2014 Chevrolet Impala My vehicle is extremely comfortable; heated and air condition seats. This car has all of the bells and whistles. I have had the vehicle for a little over 4 years, and haven’t had any major problems, other than the normal wear and tear.

To fix the problem, partial disassembly of the transmission was the only option. On average, this repair can cost around $1,000. However, since it wasn’t a life-threatening issue, many drivers opted not to get it fixed.

When did Chevy Impala get a pressure control solenoid?

The Chevy Impala’s 4T65E transmission was said to feature an updated Pressure Control Solenoid starting in 2003. This was a major issue in the 2000-2002 model years. But, there are still many people with the 2003MY vehicles that are experiencing the same issue as you.

What causes hard shifting in a Chevy Impala?

Erratic and hard shifting can occur from a failed transmission pressure control solenoid. To fix this issue, a partial dis-assembly of the transmission is necessary to replace a failed pressure control solenoid. once i am at a complete stop and i get ready to go the car will take a moment and then jerk.

What are the transmission problems on a 2002 Impala?

2002 Impala breaking system and transmission are defective. The braking calipers on the back disc on the drivers side holds less than one inch of the disc. The other three calipers go all the way normally. This has resulted in less braking capacity on one side. The transmission rolls when on a hill.

The transmission issue of shifting erratically just started but only when the car has been on the road for more then 30 minutest or so. Was checked out through a Chevrolet dealer and told it would cost $1000.00 to fix the solinoid issue.

What to do when your transmission slips on an Impala?

20 years ago I was a Snap On Tool dealer, my truck had a 427 chevy engine and Allison auto trans.I would have to let off the throttle to get it to shift from 1st to 2nd. The owner of a trans shop I serviced recommended an additive, I don’t remember what brand it was but it cured the shifting problem permanently.

Why does my Chevy Impala keep getting stuck in the ignition?

One of the most frequent Chevy Impala problems is getting the key stuck inside the ignition. Some reported that they were able to get the key out after enough turning, but most weren’t so lucky. The only way drivers were able to turn off the car was by disconnecting the battery. The cause of this issue was caused by a broken wire near the shifter.

Why is my Chevy Impala not moving out of Park?

I have a 2006 Chevy Impala and it is stuck in my garage. I cannot get the shifter to move form park to drive. It is running right now. This is a common problem. You have an issue with the shift interlock solenoid, most likely a broken wire. If you shut the car off, you may not be able to get the key completely out, so be aware of that.

One of the most frequent Chevy Impala problems is getting the key stuck inside the ignition. Some reported that they were able to get the key out after enough turning, but most weren’t so lucky. The only way drivers were able to turn off the car was by disconnecting the battery. The cause of this issue was caused by a broken wire near the shifter.

Where is the shifter on a Chevy Impala?

Some are in the front of the console near the shifter and there are some down in the compartment. One electrical connector near the front has to be disconnected, then you can lift the entire console assembly upward and out. I think the MODERATOR has a link to a picture of the wiring if you’d like.

Is the transmission slipping in my 2010 Impala?

The transmission is slipping in my 2010 Impala. It only does it from a stop but does not happen all the time. It will rev up and move very slow and then all the sudden grab. I seen a few Threads on this but did not find a solution. I have the same issue on my 2010.

Are there transmission problems in a 2007 Chevrolet Impala?

First trans was installed in 2016 October. See all problems of the 2007 Chevrolet Impala . Tl the contact owns a 2006 Chevrolet Impala. The contact stated that the transmission gears failed to properly change over in drive to accelerate. As a result, the vehicle intermittently decelerated and jerked. There was no warning indicator illuminated.

Are there any problems with the transmission solenoid on a Chevy Impala?

Chevrolet Impala owners have reported 31 problems related to transmission solenoid (under the power train category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Chevrolet Impala based on all problems reported for the Impala. 5th cylinder misfire caused by broken valve.

Why is my transmission code not working on my Impala?

Especially cause transmission codes don’t typically trigger the CEL. I noticed my 6T70 starting to develop weird issues (longer time to change from park to drive, ugly shifts, etc), and had no check engine lights. I plugged in my special scanner and it had 2 transmission codes.

The transmission issue of shifting erratically just started but only when the car has been on the road for more then 30 minutest or so. Was checked out through a Chevrolet dealer and told it would cost $1000.00 to fix the solinoid issue.

What kind of transmission does an impala have?

THE CLUTCH HUB HOUSING. THE 2-6 REACTION SUN GEAR, 1,2,3,4 CLUTCH SPRING RETAINERS AND PISTON. AS WELL AS THE GASKET FOR REAR PLATE AND SEALS. CHECKED THE TORQUE CONVERTER, WAS OK. REASSEMBLED THE TRANSMISSION WITH ALL NECESSARY SEALS AND GASKETS.

Why is my transmission not working on my Chevy Impala?

However, in today’s cars (esp the Impala) the transmission is computer controlled. So it’s hard to say. It could be the tranny, or the computer. So the fix could be as complex as overhauling the transmission or as easy flash-updating the PCM.

Is there hard shift on my Impala 6T70?

CHECK FOR HARD SHIFT AFTER PASSING ON THE INTERSTATE. ROAD TEST WITH CUSTOMER & THE BUMP SHIFT WAS HARSH ONCE THE ACCELERATOR WAS RELEASED. REMOVED THE TRANSMISSION AND DISASSEMBLE FOR INSPECTION.

THE CLUTCH HUB HOUSING. THE 2-6 REACTION SUN GEAR, 1,2,3,4 CLUTCH SPRING RETAINERS AND PISTON. AS WELL AS THE GASKET FOR REAR PLATE AND SEALS. CHECKED THE TORQUE CONVERTER, WAS OK. REASSEMBLED THE TRANSMISSION WITH ALL NECESSARY SEALS AND GASKETS.

Author Image
Ruth Doyle