What causes a bad fuel injector on a Chrysler Neon?

A bad fuel injector will cause your Neon (or any 2.0L (SOHC, DOHC), 2.4L (DOHC) equipped Chrysler vehicle) to idle rough, run rough, and light up the check engine light with either misfire codes (P0300, P0301, P0303, P0304) or fuel injector diagnostic trouble codes (P0201, P0202, P0203, P0204).

What happens when a fuel injector goes bad?

What is the code for a bad fuel injector?

P0204: Injector #4 Control Circuit. From personal experience over the years, what’s really interesting is that around 90% of the time, when you do have a bad fuel injector, you’ll see a misfire trouble code: P0301: Cylinder #1 Misfire.

How to test the fuel injectors in a Chrysler 2.0L?

To test the fuel injectors in your Chrysler 2.0L or 2.4L equipped car you don’t need any expensive tools. Here’s a basic list of tools you’ll need: A multimeter. You’ll only be using the multimeter to check resistance (Ohms).

How can I tell if my Dodge fuel pump is bad?

Start by verifying that the Dodge has a fuel problem. Also, a fuel problem does not always mean that the fuel pump in a Dodge is bad. Locate the Schraeder valve on the fuel rail. Take the cap off and install a fuel-pressure tester. Turn the key on and check the pressure. It should be 49 psi.

What are the signs of a bad gas tank?

Top 5 Signs of Bad Fuel In Your Gas Tank. 1) Acceleration Issues; 2) Abnormal Speed Changes; 3) Damaged Fuel Filter; 4) Engine Stops Running; 5) Trouble Starting Engine

Why is my 2 cylinder engine not getting fuel?

All the injectors are ticking perfectly fine. I switched injectors to stock and have 8 set of these injectors and no matter which injector I use, the #2 cylinder isnt getting fuel. The engine studders and has terrible rough idle at like 550rpm.

Can a fuel injector resistance test be done on a Dodge Neon?

A fuel injector resistance test can easily determine if a fuel injector on your Dodge Neon (or Stratus or PT Cruiser or Cirrus or Breeze, etc) is defective or not. This test doesn’t require that you use expensive testing equipment, since a simple multimeter will suffice.

Why is my fuel injector # 2 cylinder not getting fuel?

No Pulse I hooked a stethoscope to the injector #2 and it has no pulse. All the injectors are ticking perfectly fine. I switched injectors to stock and have 8 set of these injectors and no matter which injector I use, the #2 cylinder isnt getting fuel. The engine studders and has terrible rough idle at like 550rpm.