What cast is used in Colles fracture?

What cast is used in Colles fracture?

Two types of casts are used: plaster splint for 7–10 days and later exchanged to a circular cast and the use of circular cast immediately. The objective of this work is to compare both types of treatment in terms of ability to achieve reduction and to maintain it during healing.

What is a Colles cast?

A Colles’ wrist fracture occurs when the radius bone in your forearm breaks. It’s also known as a distal radius fracture, transverse wrist fracture, or a dinner-fork deformity of the wrist.

How long do you wear a cast for a wrist fracture?

Usually a cast will remain on for up to six weeks. Then you will be given a removable wrist splint to wear for comfort and support. Once the cast is removed, you can start physical therapy to regain proper wrist function and strength.

Do wrist fractures need a cast?

Immobilization. Restricting the movement of a broken bone in your wrist is critical to proper healing. To do this, you’ll likely need a splint or a cast. You’ll be advised to keep your hand above heart level as much as possible to reduce swelling and pain.

When applying a cast the plaster is applied?

Apply the plaster by unrolling the bandage as it rests on the limb. Do not lift it up from the patient or apply tension to the roll. Overlap the previous layer of plaster by about half the width of the roll. 6.

How do you apply a cast?

How Are Casts Put On?

1. wraps a liner of soft material around the injured area (for a waterproof cast, a different liner is used)
2. wets the cast material with water.
3. wraps the cast material around the first layer.
4. waits until the outer layer dries to a hard, protective covering.

Which is an example of a plaster cast?

In this two-part article, plastering techniques will be discussed through the examples of a Colles’ fracture cast (part 1) and a volar forearm slab (part 2, in our next issue). Almost all other plasters are variants of these two examples, differing only in site and size.

Can a cast be used as a splint?

1. General principles unstable fractures in some low demand patients (when some degree of malunion may be tolerated) It may not be possible to maintain reduction of a fracture in a cast, but a cast may be useful as a splint to help relieve pain.

When to change from a backslab to a cast?

o Backslabs vs casts: for acute injuries, a ‘backslab’ (i.e. slab of plaster on one side of the limb) should be used to allow for swelling. This is then changed to a more secure full ‘cast’ (i.e. circumferential around limb) at ̴1 week post injury. Check cast prescription Preparation part