What can be done about the Dodge Ram 1500 sunroof?
What can be done about the Dodge Ram 1500 sunroof?
What can be done about the sunroof on a Dodge Ram 1500 which opens and closes fine but stops short of the end of the closing cycle and does not seal tight? The sunroof will need to be recalibrated and then the module will have to be flashed by a dealer. Here is the recalibration process:
Where is the fuse on a Dodge Ram sunroof?
The fuse can be located in a box under the hood, in front of the wheel well. Replace the fuse and all functions should be restored. What can be done about the sunroof on a Dodge Ram 1500 which opens and closes fine but stops short of the end of the closing cycle and does not seal tight?
How can I Stop my Dodge sunroof from closing?
When the EFL acts, the motor stops and reverses the movement of the roof. Try overriding the EFL by actuating the close switch continuously which should force the sunroof closed. During this operation, if the close switch is released, the closing motion will cease.
Where does water come from in a Dodge sunroof?
Case details: Water flows out of screw holes in the front molding. Check the drain line before it touches the grommet for splits and cracks and ensure it is properly seated in the grommet. Remove the grommet, reinstall and seal it around the edges as the grommet hole is a known potential leak source.
How do you calibrate a Chrysler sunroof?
Press the vent button on the power sunroof switch and hold until the sunroof glass panel has moved to the full vent position and the motor movement has stopped for at least 1 second. 3. Press the close switch on the power sunroof switch and hold for a moment (at least 100ms) and release.
How can I Fix my Dodge Ram sunroof?
1. Turn the ignition to the RUN position. 2. Press the vent button on the power sunroof switch and hold until the sunroof glass panel has moved to the full vent position and the motor movement has stopped for at least 1 second. 3. Press the close switch on the power sunroof switch and hold for a moment (at least 100ms) and release.
How to calibrate a Dodge Challenger sun roof?
This procedure has worked for JGC and Charger/300/Challenger/Magnum owners. Its for when the sunroof is closing too high or low. Steps 1-6 are for using a Starscan thus starting with #7. 7. Place the ignition switch in RUN position. 8. Close all of the doors. 9. Press and release the vent switch (sunroof should move to vent position). 10.
Is there a problem with the sun roof calibration?
Once the sunroof stops moving the calibration is complete. If you are still having issues, you could possibly have a sensor that has died. When I close the sunroof from the Vent positions it seems to be higher along the rear edges than when I close the sunroof from any Open position.
Press the vent button on the power sunroof switch and hold until the sunroof glass panel has moved to the full vent position and the motor movement has stopped for at least 1 second. 3. Press the close switch on the power sunroof switch and hold for a moment (at least 100ms) and release.
