What are the radio wires on a Dodge Durango?

The rear view camera wires are dk. green/brown – dk. green/orange at the radio, 52 pin plug, pins 31 – 32. The CD changer audio left wires are dk. green/white – gray/orange at the radio, 52 pin plug, pins 10 – 9. The CD changer audio right wires are gray/white – gray/orange at the radio, 52 pin plug, pins 8 – 9. Thank you! Sweet Jesus Redline!

Where is the fuse box in a Dodge Durango?

Fuse box in passenger compartment Dodge Durango. fuse box location. The junction block is located in the end cover at the left side of the instrumental panel. fuse box layout. type 1. Headlamp Switch, Overhead A/C Control, Instrument Cluster, Radio, Rear Wiper/Defogger Switch, Ash Receiver Lamp & A/C-Heater Control

What are the electrical plugs on a Dodge Durango?

The LR – RR are white/gray – white/orange (+) at the BCM above passenger kick, white 48 pin plug (F), pin 32; black 48 pin plug (E), pin 4. On models with power liftgate, the open/close is purple/tan (- 4700 ohms) at the Electronic Overhead Module, black 16 pin plug, pin 15.

Where is the blower resistor on a Dodge Durango?

On a 2001 the blower resistor is located in the ductwork below the glove box to the left of the blower motor. You will need to loosen the lower floor duct to access it (it is mounted vertically behind it, look for the connector with the multi colored wires including green and black).

What was the ground wire on my Dodge Durango?

We took the engine apart in my dodge durango 2001 4.7 and now i cannot remember what the ground wire was attached to.

What kind of electrical system does a Dodge Durango use?

All them items are controlled by the Front Control Module. Has your mechanic checked for codes. The 2004 and up Durangos use a CAN (Controller Access Network) Bus based system. A traditional OBDII scanner will not work. It has to be CAN capable. If your mechanic does not have one, then you need to look else where.

Where can I find a car stereo wiring diagram?

You can either track down a wiring diagram for that specific make, model, and year, or you can grab an inexpensive multimeter, which is an essential tool for DIY car stereo wiring projects , and an AA battery, and figure it out on your own.

How do you check for continuity in a car stereo?

You just have to connect the ohmmeter to a known good ground and then check each of the wires in the car stereo harness for continuity. The one that shows continuity is your ground, and you can move on. You can also check for the ground wire with a test light, although it’s a better idea to use an ohmmeter if you have one.