Common questions

Is there a way to permanently seal the sunroof?

Is there a way to permanently seal the sunroof?

If your car’s sunroof won’t stop leaking, you may choose to seal it permanently — possibly the most effective solution to this problem. With a few items from the hardware store, you will have all the materials you need to seal your car’s sunroof permanently. You will create a waterproof seal using silicone that will be resistant to sunlight.

What to do if your Volvo sunroof won’t open?

The other thing is to remove the cover from the sunroof motor. There is a large screw with a button in the middle on the motor assembly. Turning the screw with a screwdriver will depress the button and allow you to move the sunroof BUT, it also adjusts the stop location for open and closed. Sunroof Won’t Open to Vent Position.

Is the power sunroof on my 91 940T working?

[Inquiry] The power sunroof on my ’91 940T has stopped functioning, and is stuck all the way “open” (tilted up, rather) and won’t go back down. This follows a few weeks of CLICCLICKLCLIK when opened/closed, and some erratic operation.

Where are the sunroof liners on a Volvo?

They are at the back of the sunroof, one left and one on right. You can unhook them with your coat hanger wire. The sunroof liner can then be slid back out of the way (don’t push it to far back)under the roof and above the headliner. With the liner out of the way you can check all the bolts and screws.

If your car’s sunroof won’t stop leaking, you may choose to seal it permanently — possibly the most effective solution to this problem. With a few items from the hardware store, you will have all the materials you need to seal your car’s sunroof permanently. You will create a waterproof seal using silicone that will be resistant to sunlight.

Why is my sunroof not closing flush with the roof?

If you notice that when you close your sunroof, that it is not closing to the proper position; either too high or too low, so as not to seal correctly, you can use this fix to recalibrate the sunroof closed position. This is from a TSB from 2005. Steps 1 throug 6 concern reprogramming the sunroof module with Starscan (deleted).

How do you close the sunroof on a car?

To use this method, you should turn the ignition switch on. Then push the sunroof button forward to close if it is not already closed, then release the button. Now, push to sunroof button forward again and hold until the sunroof tilts and moved slightly, and then release.

What happens if my Volvo sunroof does not move?

If your roof does not move at all, you must NOT pry up the rear edge manually as there are cast tracks at the rear of the panel that hold it in place and you will break, bend, or damage the tracks, roof or the panel.

What happens if you have a leak in your sunroof?

Whether it’s dripping or gushing water, a sunroof leak can create a mess and damage your car’s interior. While you may assume that the rubber seal on your sunroof is damaged and needs repair, oftentimes the culprit isn’t the seal at all.

If you notice that when you close your sunroof, that it is not closing to the proper position; either too high or too low, so as not to seal correctly, you can use this fix to recalibrate the sunroof closed position. This is from a TSB from 2005. Steps 1 throug 6 concern reprogramming the sunroof module with Starscan (deleted).

Where are the small holes in the sunroof?

These are very small holes, usually at the corners of the sunroof just under the seal. Blast compressed air through the drain tubes located at the base of the sunroof seal. These tubes are designed to carry water that gets through the roof down and out of the car.

Can a faulty seal cause a sunroof to leak?

You can follow these simple steps to fix a clogged drain after leaks occur, or you can do it as part of preventative maintenance to prevent it from ever happening. A faulty seal may be the cause of a sunroof leak. But the most common cause of a sunroof leak is a clog in the drainage system that carries the water away.

Can you use silicone to seal a sunroof?

You will create a waterproof seal using silicone that will be resistant to sunlight. Keep in mind that once you seal your sunroof, you will not be able to open it again without scraping off the silicone.

What to do if your sunroof is missing?

If the seal of your sunroof is missing, use the tape to cover the crack where it was. Put the tape over the entire edge of the seal, not just any damaged parts so there’s a watertight seal around the sunroof.

What to do if your sunroof is not closing flush with the roof?

If it sits too high or low, the fix is really easy. With the sunroof closed, and the shade open, you will see two accordion looking pieces on either side. They just snap into place with two tabs (one in front one in back) connecting them to the glass. pull them out with your fingers and let them drop down.

What happens when you close the sunroof on a car?

When holding down the close button, the sunroof should cycle through the open, closed and vent positions on its own. Once the sunroof stops moving the calibration is complete. If you are still having issues, you could possibly have a sensor that has died.

Why is the sunroof higher than the roof?

If you are still having issues, you could possibly have a sensor that has died. When I close the sunroof from the Vent positions it seems to be higher along the rear edges than when I close the sunroof from any Open position. So I try to open the sunroof and then close it so it will be in the position where the rear edge is more flush to the roof.

What should I do if my sunroof is not closing?

Place the ignition switch in RUN position. 8. Close all of the doors. 9. Press and release the vent switch (sunroof should move to vent position). 10. Once the sunroof has stopped motion at the vent position, press and hold the vent switch for at least 5 seconds to recalibrate the sunroof position. 11.

What to use to seal a sunroof on a car?

Caulk around the sunroof with the silicone. Pour enough to cover the gap between the glass and the roof. If your sunroof has any seams in the middle, pour silicone into all seams.

If you are still having issues, you could possibly have a sensor that has died. When I close the sunroof from the Vent positions it seems to be higher along the rear edges than when I close the sunroof from any Open position. So I try to open the sunroof and then close it so it will be in the position where the rear edge is more flush to the roof.

Is there a problem with the sun roof calibration?

Once the sunroof stops moving the calibration is complete. If you are still having issues, you could possibly have a sensor that has died. When I close the sunroof from the Vent positions it seems to be higher along the rear edges than when I close the sunroof from any Open position.

Author Image
Ruth Doyle