Is there a problem with the ignition switch on a Dodge Ram?

Seems to be an ongoing issue with the same defective ignition switch in these vehicles as the Ford, Honda, Acura, Lexus, Toyota, and Infinity that all use the same bad parts. Change the ignition switch and consider yourself lucky you didn’t get cheated by crooked dealerships and dishonest manufacturers. 58 people found this helpful.

How to fix intermittent start problem with Ram 1500?

DON’T DO THIS WITH ONE CONNECTED TO THE BATTERY, COMPLETELY UNHOOK YOUR BATTERY FROM BOTH CABLES before touching them together. did the trick. lock/unlock worked, and it started right up. some crazy kind of hard reboot of the computer that my buddy found online while we were troubleshooting… 31 people found this helpful.

Are there any problems with the Dodge Ram 1500?

Definitely not the starter.. Known to be problems with these Ram 1500 are faulty ignition switches that burn out but not completely so they work intermediately. if you have enough juice in your battery to run all your lights and accessories then the starter would make at least a half-assed attempt..

What are the problems with a 2002 Dodge Ram 1500?

Lighting issues are common in Dodge Ram trucks and are one of the most frequently-cited 2002 Dodge Ram 1500 electrical problems specifically. Owners find that their headlights, taillights or turn signals suddenly stop working, causing irritation at best and a safety hazard at worst.

Why is my Dodge Ram 1500 not shifting?

The transmission may also slip or refuse to shift at all, which is one of the main 2006 Dodge Ram 1500 transmission shifting problems. Sometimes switching out the solenoids can fix the problem for around $50 to $100 plus labor if you have it done by a shop.

Why does my Ram 1500 not start up?

Turn the key, gauges radio everything but the starter comes on. The trick I found I’d if I hold the ignition switch to the starting position, 15, 30, a minute, sometimes longer, it’ll finally crank over and start. Not sure what’s causing this.

Where can I get electronic keys for my Chrysler Silverado?

Go to your Chrysler dealer, with proof of ownership, and your VIN number, and write them a check. The dealer is the only source of electronic keys and programming… I would suspect that the steering is electronic and something was not making contact when you were going over the bumps and caused the steering to lock.

Why is my key not turning on my Dodge Ram?

While there are a variety of reasons your Dodge Ram 1500 key won’t turn, the most common 3 are a binding steering column/lock, an ignition switch issue, or a problem with the ignition key.

What happens when you turn the key to start a Dodge Caravan?

I have a 2002 Dodge Caravan when I turn the Key to start I get nothing, no lights, no nothing if the key is in the on or off position still nothing, no dash lights no headlights no nothing. nothing also with a battery charger on the battery.

How to reset PCM and check engine light in Dodge Ram?

The reset procedure in your Dodge Ram is as easy as they come. First, park your truck and turn it off. Pull the hood lever under the driver’s side dash, and then pull the safety catch on the front of the hood to open it. Find the power distribution center (PDC); it will be a black box near the battery. Unlatch and open the cover of the PDC.

Can a bad ignition switch cause an engine to not start?

The engine does not start. An engine that refuses to start can be another sign of a bad ignition switch. The ignition switch sends power to the the starter motor, engine controls, and ignition controls. These systems may not receive the power they need to start up if the ignition switch isn’t working properly.

What are the signs of a failing ignition switch?

Common Signs of a Failing Ignition Switch Engine Will Not Start. The problem here is probably: An anti-theft fault; Fault in the fuel pump circuit; Ignition circuit; Engine computer; If the anti-theft light is flashing, the computer is NOT recognizing the key or key fob and is; preventing the engine from starting.

What happens when the ignition switch on a Dodge Ram goes bad?

Your Ram stalls because the faulty switch turns off the fuel pump or power to the ignition. When this happens, the engine will not be able to run until it gets that signal back. 2. Starts then Dies If your Dodge Ram is starting right up, but then immediately dies, that is a very good indication that the ignition switch is bad.

Why does the starter on my Ram 1500 not work?

If your RAM 1500 starter does not work at all or only works very slowly when starting, an empty car battery could be to blame. For example, low temperatures have a significant impact on loading capacity. But there are other causes for a lack of ignition current.

What are the symptoms of a bad ignition switch?

Your Dodge Ram ‘s ignition switch is one of the most vital items on the entire vehicle. If it fails, the entire vehicle won’t be able to run. We’ve compiled some of the most common symptoms of a bad ignition switch. These include stalling issues, not starting, and no power to the radio or accessories.

Why are the gauges on my Dodge Ram not working?

The interior lights come on the radio comes on but the gauges themselves do not work. I hate to say it but it your ECM might be bad. Check your fuses, relays, and wiring. If none of those work, hook up a diagnostic and see if there’s any codes that you can see to fix it before my assumption. 8 people found this helpful.

What’s the Accessory position on an ignition switch?

Insert the key and turn it to the “accessory” position. The ignition switch needs to be set to the accessory position before you can release it from the ignition module. The “accessory” position is before the starter is engaged, and would normally let you run the vehicle’s electronics without the engine running (when the battery is connected).

What is the wiring diagram for a Dodge Ram?

Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2004-2005 Dodge Ram . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle.

What to do if your key is stuck in the ignition switch?

The key may be stuck in the ignition switch, but that shouldn’t stop you from turning it. If you don’t have a key, you will need to force the module to turn using a flathead screwdriver. Press the release pin inside the hole on the ignition module with a screwdriver.

Can a Dodge Ram 1500 ignition lock cylinder go missing?

Tough and dependable, your Ram 1500 delivers everything you need in a work pick-up. When your key goes missing or when the ignition cylinder does not engage, a new Dodge Ram 1500 ignition lock cylinder from AutoZone gives you a new lock and key pair to keep your Ram secure. Use the form above to tell us what you drive.

What kind of resistor does a 2004 Dodge Ram have?

NOTE #7: For the 2004 model year vehicle, to ARM/LOCK will reuire a (-)Negative thru a 2000 Ohm Resistor and to DISARM/UNLOCK requires a (-)Negative thru a 480 Ohm Resistor. A Single Pulse thru the 480 will DISARM without Unlocking. Double Pulse to UNLOCK.