How to turn off the light and beeper on Cat 277c?

How to turn off the light and beeper on Cat 277c?

At first the light and beeper came up and stayed on until forward motion stopped and hand was off joystick. Then after a while it actually stopped the machine, no forward or backward motion just the bucket still operating fine. Turn off the machine and do a full restart and it came back again.

How does a cat 277c exclamation warning work?

Pop off both plugs and they were perfectly clean, not even a spec of dust had penetrated the plug seals. The sheath close to the sensor was wrapped around the hydraulic fitting and then went down to the sensor but there were two small perforations in the sheath close to the large hydraulic nut.

Where is the cable on a cat 277c?

The right side cable was beautifully placed in a cleft created by the two hydraulic lines. Well protected and laid. Left side was a mess. Wrapped around hydraulics, more exposed, clearly no care placing that when the machine was wired.

How are speed sensors on a cat 277c?

The speed sensors break away from the main loom at two plugs. Then each side has a short 650mm plug to plug loom with the four wires in it. These looms exit the sides of the machine and plug to the sensors. I started out inside the machine at the entry to the first plugs from the ECM and had 8.14v on both sides of the plug.

Where can I find part number for cat 277c?

I’ll check with Cat in Melbourne but I’m thinking that it’s going to be prohibitively expensive and I may have to get one from the States. Seems that the part number is 2623764 and it looks like the attached image. Would anyone with a parts manual care to confirm the number for me please?

How old is my cat 277c track loader?

Discussion in ‘ Track Loaders ‘ started by uzz32soarer, Jan 27, 2016 . Hi Guys, I’m a newbie here from the other side of the World but I’m having an issue that needs some outside expertise. I have a 277C with only 200 hours on it, but it is three or four years old.