How to reset service light on Chevy Silverado?

The reset procedure is tedious, and as most Chevy owners agree, unorthodox. However, this procedure must be completed in order to reset the service light. Set the truck to park. Turn the ignition to the RUN position, while the engine remains turned off.

What is the service tire monitor light on a Chevy Silverado?

This article applies to the Chevrolet Silverado 1500 (1999-2006). The service tire monitor light is a warning bulb connected with the TPMS or Tire Pressure Monitor System, which notifies the driver of low or high air pressure in the tires.

Why is the service tire monitor light not turning off?

These sensors became especially popular on vehicles from the late 1990s onwards, and are a prominent feature on first generation Silverado 1500’s. Although the feature itself does well in preventing damage from under or over-inflated tires, the sensor can become worn or damaged, resulting in a light that will not turn off.

How to replace tire sensor on Chevy Silverado?

However, once the the tire is removed, use the following instructions to replace the sensor. Mount a wrench on either side of the TPMS sensor and break it loose from the wheel. Remove the old sensor. Place the sensor behind the wheel. Mount the new sensor to the wheel. Figure 3. TPMS. If playback doesn’t begin shortly, try restarting your device.

Why is my Service StabiliTrak not working on my Silverado?

There are many things that can cause the StabiliTrak system to lose its ability to function. It is a complex system. Wheel Speed Sensor – If one of the wheel speed sensors is out, your Silverado will no longer be able to tell if all of the wheels are turning at the same speed. Without this data it’ll turn on the service StabiliTrak warning.

Why is my traction control not working on my Chevy Silverado?

Traction Control Not Working – Your Silverado’s traction control system mostly uses the same sensors to determine if a wheel has broken traction. Unlike StabiliTrak, which controls lateral issues (sliding), traction control keeps the wheels from unnecessary spinning.

What is the GM service 4 wheel drive message?

GM has issued a service bulletin # 09-04-21-001 to address a Service 4 Wheel Drive Message condition on the vehicles listed below. In addition to the Service 4 Wheel Drive Message, you may also have a C0387 or a C0569 trouble code stored.

Where is the owner manual for a 2011 Chevy Silverado?

Chevrolet Silverado Owner Manual – 2011 Black plate (4,1) iv Introduction Using this Manual To quickly locate information about the vehicle, use the Index in the back of the manual. It is an alphabetical list of what is in the manual and the page number where it can be found. Danger, Warnings, and Cautions

Where are the air vents on a 2011 Chevy Silverado?

Instrument Panel Instrument Panel (Base/Uplevel Version) Chevrolet Silverado Owner Manual – 2011 Black plate (3,1) In Brief 1-3 A.Air Vents on page 8‑10. B. Turn and Lane‐Change Lever. SeeTurn and Lane-Change Signals on page 6‑6.

Where are the hazard warning flashers on a Chevy Silverado?

Windshield Wiper/Washer on page 5‑4. C. Driver Information Center (DIC) Buttons. SeeDriver Information Center (DIC) on page 5‑32. D. Hazard Warning Flashers on page 6‑5(Out of View). E. Instrument Cluster on page 5‑12.