How to replace the PassLock sensor on a GM car?
How to replace the PassLock sensor on a GM car?
Find the three wires that connect the Passlock Sensor to the Body Control Module and substitute our circuit for the Passlock Sensor. Perform the “Relearn” Procedure so that our Body Control Module recognizes our new circuit. Go to Radio Shack and buy a Mini Terminal Block, and a package of 2200 ohm (2.2k-Ohm) resistors.
Where do I find the PassLock sensor code?
The vehicle learns the Passlock™ Sensor Data Code and/or password on the next ignition switch transition from OFF to Crank. You must turn the ignition OFF before attempting to start the vehicle. Start the engine (the vehicle has now learned the Passlock™ Sensor Data Code and/or password)
How long does it take for PassLock sensor to turn off?
•Observe the security light located in the instrument cluster, after approximately 10 minutes the security light will turn OFF. Turn OFF the ignition, and wait 5 seconds. •The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.
How to bypass the PassLock sensor on a 2002 Pontiac Grand Am?
This web page will guide you through the steps necessary to bypass the “Passlock Sensor” on a 2002 Pontiac Grand Am, and keep the “SECURITY” light off forever. The steps necessary are similar on the other models listed above. There are generally only minor differences in how to get the radio out to get to the wires.
Find the three wires that connect the Passlock Sensor to the Body Control Module and substitute our circuit for the Passlock Sensor. Perform the “Relearn” Procedure so that our Body Control Module recognizes our new circuit. Go to Radio Shack and buy a Mini Terminal Block, and a package of 2200 ohm (2.2k-Ohm) resistors.
How long does it take to reset PassLock on a Chevy?
Reset security system on chevy, buick, oldsmobile, cadillac, pontiac, saturn, hummer. Make sure the battery if fully charged because this procedure may take up to 30 minutes and you cannot start the vehicle during this time. The instrument panel cluster (IPC).
The vehicle learns the Passlock™ Sensor Data Code and/or password on the next ignition switch transition from OFF to Crank. You must turn the ignition OFF before attempting to start the vehicle. Start the engine (the vehicle has now learned the Passlock™ Sensor Data Code and/or password)
•Observe the security light located in the instrument cluster, after approximately 10 minutes the security light will turn OFF. Turn OFF the ignition, and wait 5 seconds. •The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.
Where is the PassLock switch on a Chevy?
The switch allows the car’s passlock system to be switched on or off by splicing with a yellow wire that’s plugged into the cylinder lock. Once completed, the new switch should be placed underneath the dash right below the key hole.
Where is the sensor for key pass-lock located?
Where Is the Passlock Located ?: Where Is the Sensor for Key Pass-… Where is the passlock located? Where is the sensor for key pass-lock. In the key tumbler or housing for key lock?
The switch allows the car’s passlock system to be switched on or off by splicing with a yellow wire that’s plugged into the cylinder lock. Once completed, the new switch should be placed underneath the dash right below the key hole.
How much does it cost to replace a PassLock sensor?
Rinse, repeat, and cry. A more permanent solution is to either replace the ignition lock cylinder or bypass the sensor. Replacement cylinder with new sensors can cost, with labor, as much as $450. Bypassing the sensor will void any warranty, but since most of these vehicles are out-of-warranty at this point that might not be of any concern.
