How to fix a 2005 Chevy Colorado door lock?

Click to expand… I also have a 2005 Chevy Colorado with the exact same problem. I followed the advice given, that is removing the negative battery cable and holding it against the positive terminal on the battery for 30 seconds to completely discharge the BCM (body control module) and waiting 6 hours then reconnecting the battery cable.

Why does my Chevy Colorado not start up?

Lights go out but starter does not engage. Brand new battery as of today. It started after several attempts and an hour of waiting, but as soon as the truck is turned off it won’t start again. At one point the keyless entry, electric locks, and drivers side windows would not work.

Why does my Colorado window lock not work?

The resistor and connector is an easy fix with the link ssgjurista gave you. I think the problem is the contacts between the two most times rather than the resistor itself.

Why does my Colorado door lock not work?

Then found the locking system did not work either. I disconnected the battery cables and shorted them together and came back in an hour and reconnected them and all works good now. my colorado is a 2006, I wonder if they have fixed this quirck in the newer models. Thanks for the post, this saved me big bucks at the dealership.

Why are my key fobs not working on my truck?

Both of my key fobs wont lock or unlock my truck. All my doors are closed and the hood if firmly latched. Batteries are new, just replaced them today. Click to expand… You could try the “fix all” of pulling the neg battery cable for 20 minutes or so. Yeah, did that. Left it off for an hour. After I put it back on, it let me lock the truck.

How to fix driver side power door lock?

1. disconnect the battery and connect both the positive and negative cables together(after disconnected)) 2. disconnect the window and lock controller in the driver’s side door. 3. Leave cables connected for at least 5 minutes 4. Re-connect door window controller and locks wiring harness 5.

What to do if your driver side window does not work?

Shut the truck off and start again. Put in gear and you should hear the door locks activate again and your driver side window should work again. If that doesn’t do the trick, unplug the black harness again (with the ignition off), spray wd40 into any connection that has corrosion and blow connection clean with air.

How can I get my truck door lock to work?

Grab the BLACK wire harness on top, wiggle and push it in firmly. Start the truck and let it run for several minutes (maybe 5 or so) so the computer and control module can do what their best at. Shut the truck off and start again. Put in gear and you should hear the door locks activate again and your driver side window should work again.

Why does my driver side door lock not work?

The windows and the locks are on two separate circuits. The only part that these two have in common is the master switch. Of course it is also possible that the wiring harness between the driver side door and cowl is corroded and that some of the pins are to corroded or even broken off and do not make contact.

Why does my drivers side window not work?

A smaller version of GM’s rebirth of the Hummer. Hard to start yesterday,drivers side window,power door locks wont work,either by buttons on both doors or on key fob.Other windows work! Replaced Battery checked door lock fuse,still no drivers side window or door locks. Answered! View the answer I have this problem too Is this a good question?

How to fix a 2005 Chevy Colorado door lock?