How to clean a Mercedes Sprinter diesel engine?

How to clean a Mercedes Sprinter diesel engine?

Remove the upper supply hose to the inlet manifold. Remove the air box lid and take out the filter, extract the air box base. Take off the turbo supply pipework and disconnect the crankcase breather heater. Remove this hose from the breather oil/separator.

How to remove Turbo from Mercedes Sprinter engine?

Remove the turbo hoses from either side, to and from the intercooler. Remove the upper supply hose to the inlet manifold. Remove the air box lid and take out the filter, extract the air box base. Take off the turbo supply pipework and disconnect the crankcase breather heater. Remove this hose from the breather oil/separator.

Where are the water hoses on a Mercedes Sprinter?

Undo the water hoses from the engine, (at the thermostat and water pump spigots) then release the hose from the steel pipe above the exhaust manifold and the one on the opposite side feeding the electric circulation pump. Remove the turbo hoses from either side, to and from the intercooler. Remove the upper supply hose to the inlet manifold.

How to charge a Mercedes Sprinter diesel engine?

Remove the power steering pump and place it where the headlamp usually resides Disconnect the charge air pressure sensor plug and inlet air temperature sensor from the plastic duct. Remove the charge air rigid duct from the area of the right hand headlamp, there are two torx screws accessed from the rear area of the right headlamp

Remove the upper supply hose to the inlet manifold. Remove the air box lid and take out the filter, extract the air box base. Take off the turbo supply pipework and disconnect the crankcase breather heater. Remove this hose from the breather oil/separator.

Remove the turbo hoses from either side, to and from the intercooler. Remove the upper supply hose to the inlet manifold. Remove the air box lid and take out the filter, extract the air box base. Take off the turbo supply pipework and disconnect the crankcase breather heater. Remove this hose from the breather oil/separator.

Undo the water hoses from the engine, (at the thermostat and water pump spigots) then release the hose from the steel pipe above the exhaust manifold and the one on the opposite side feeding the electric circulation pump. Remove the turbo hoses from either side, to and from the intercooler. Remove the upper supply hose to the inlet manifold.

Remove the power steering pump and place it where the headlamp usually resides Disconnect the charge air pressure sensor plug and inlet air temperature sensor from the plastic duct. Remove the charge air rigid duct from the area of the right hand headlamp, there are two torx screws accessed from the rear area of the right headlamp