How to change transmission on GMC 4L60E?

Use a couple of bolts to orient the new gasket and secure the pan back to the trans. Replace the remaining bolts and get them finger tight. Torque them to 97 in-lbs. Next, replace the rear Torx screw on the shift linkage bracket and tighten the front one.

How do you change a transmission filter on a Chevy truck?

Properly discard the old filter. Install the new filter being careful to include any filter gasket, “O” ring or filter seal that came with the filter. Replace the clips or bolts where necessary. Use a small amount of grease on the pan’s gasket area and position the gasket in place. Do not use adhesives, cements or sealants on the gasket.

What kind of transmission filter does ACDelco use?

The Professional, premium aftermarket Automatic Transmission Filter Kit includes the materials to mount a transmission filter in place. This automatic transmission filter kit meets the performance standards you would expect from ACDelco.

What kind of transmission is the 4L60E?

What is a 4L60E Transmission? The 4L60-E is an automatic shift, four-speed overdrive, longitudinally positioned transmission. It has been considered to be the best rendition of the finest overdrive automatic transmission ever produced.

Why does my 4L60E have no reverse?

Slow, slipping or no reverse: “lo-reverse” clutches are worn out, fluid leak in the reverse apply circuit, or broken sunshell.

How much fluid does a GM 4L60E need?

The 4L60E transmission weighs 146 pounds dry, and 162 wet. It requires 8.4 quarts (9.64″ torque converter) or 11.4 quarts (11.81″ torque converter) of transmission fluid, Below is a list of common transmission problems with the GM 4L60E Transmission and possible solutions to repair.

What causes a WoT Shudder on a 4L60E?

3. 1-2 Shift shudder at WOT (Wide Open Throttle); delayed or abnormal 1-2 shift; There’s a problem ONLY on the 1-2 shift: 1-2 accumulator piston cracked or stuck cocked in the bore. Check the yellow spring inside the accum housing for breakage.